489452
113
Zoom out
Zoom in
Vorherige Seite
1/117
Nächste Seite
English
1HR.
TIMER
ON/OFF
operation
ACL
(Reset)
QUIET
button
button
button
button
LED CLEAN lamp
TIMER lamp
OPERATION lamp
Fig. 59a-1
Fig. 59b-1
Fig. 59c-1
LED CLEAN lamp
TIMER lamp
OPERATION lamp
Fig. 59c-2
(SAP-KMRV76, KMRV96, KMRV126)
(SAP-KRV186, KRV246)
(SAP-KRV96, KRV126)
21
For indoor unit types
(SAP-KMRV76EH, KMRV96EH, KMRV126EH)
(SAP-KRV96EHDS, KRV126EHDS)
(SAP-KRV186EH, KRV246EH)
After turning on the power of the air conditioner, use the remote
controller and follow the steps below to conduct the test run.
(1) Set the remote controller in Test Run mode. (Fig. 59a-1)
a)Press and hold the QUIET button and the 1HR. TIMER button.
b)Then press and hold the ACL (Reset) button with a pointed
object such as the tip of a pen. After 5 seconds, release the
ACL button first.
c)Then release the QUIET and 1HR. TIMER buttons.
d) appears and “oP-1” blinking in the remote controller clock
display area. (Fig. 59b-1)
(2) Start Cooling mode test run by pressing the ON/OFF operation
button of the remote controller. (Fig. 59a-1)
This starts the fan producing uncooled forced air with the 3 indi-
cator lamps (OPERATION lamp, TIMER lamp, and LED CLEAN
lamp) on the main unit blinking. (Fig. 59c-1 or 59c-2)
After 3 minutes, the system shifts into cooling operation, and
cool air will start to be felt. Cooling mode test run is unaffected
by the room temperature.
(3) Press the ON/OFF operation button of the remote controller again
to stop the test run. (Fig. 59a-1)
(4) Finally press the ACL (Reset) button of the remote controller to
release it from Test Run mode to return to normal mode.
(Fig. 59a-1)
” and “oP-1” will disappear from the remote controller clock
display area.
After the test run is completed, be sure to press the ACL (Reset)
button to return to normal mode. The air conditioner will not operate
correctly if this is not done.
IMPORTANT
08-324 CMRV3656EH_IU EN 6/15/09 5:28 PM Page 21
113

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sanyo SAP-KMRV126EH wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info