699878
2
Zoom out
Zoom in
Vorherige Seite
1/4
Nächste Seite
2 AMD-102 SATEL
3. Description
The detector takes up two positions in the ABAX system (first: magnetic contact; second:
additional inputs). For some alarm systems, you can select when adding the detector, whether it
will occupy one or two positions on the list of devices. If the detector occupies one position, only
additional inputs are supported.
Electronics board
Figure 1 shows the inside of the detector.
CR123A lithium battery.
tamper switch.
terminals:
R - roller shutter input (if no detector is connected to the input,
connect the input to common ground).
COM - common ground.
M - NC type input (if no detector is connected to the input,
connect the input to common ground).
The LED and reed switches are placed on the other side of the
electronics board.
Alarms
The detector reports alarm in the following cases:
opening enabled reed switch contacts after removal of magnet,
opening the NC type input,
recording the specified number of pulses within a defined time period
by the roller shutter input,
opening the roller shutter input (tamper alarm),
opening the tamper contact (tamper alarm).
Operating modes
The detector operating mode is defined remotely.
Active – information about each alarm is sent immediately.
Passive – information about tamper alarm is sent immediately, while information about other
alarms is sent only during the polling time. This operating mode prolongs the battery life.
Test mode
If you want to test the detector, you can remotely start the test mode. When in the test mode, the
detector LED is working.
LED
The LED is working for 2 minutes after battery is inserted, as well as in the test mode. The LED
indicates:
polling – short flash (80 milliseconds),
alarm – ON for 2 seconds.
Battery status control
When the battery voltage is below 2,75 V, information about low battery is sent during each
transmission.
Note: For additional information about the detector and its configuration please refer to the
manual for ABAX wireless system controller.
4. Installation
There is a danger of battery explosion when using a different battery than
recommended by the manufacturer, or handling the battery improperly.
2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Satel AMD-102 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Satel AMD-102

Satel AMD-102 Bedienungsanleitung - Deutsch - 4 seiten

Satel AMD-102 Bedienungsanleitung - Holländisch - 4 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info