779959
4
Zoom out
Zoom in
Vorherige Seite
1/10
Nächste Seite
A B
A B
+=3-4mm
2
2
1
1
A
B
C
1 mm 1 mm
12
1 1
2 2
BC
B+C=2 mm
ENGLISHENGLISH
BRAKES
GENERAL BRAKE ADJUSTMENT
Your SCOTT bike is fitted with a reliable and well‑functioning braking system,
provided the brakes are correctly adjusted. Check by measuring the distance
between the brake shoes and the rim: it should be 1.5 to 2 mm.
Cable connection and adjustment of the (Dual Pivot) brake
1. Put the quick release lever in
the closed position.
2. Adjust the brake shoe
clearance (as shown in the
illustration) and secure the
cable with the pinch bolt nut.
Cable bolt tightening
torque 68 Nm
HOW TO CHANGE BRAKE PADS
1. Loosen the security screw with a 2 mm allen key.
2. Push the used brake pad out of the aluminum brake shoe.
3. Push the new brake pad into the brake shoe, according to the arrow showing the
mounting direction.
4. Tighten the security screw to approximately 1.5 Nm.
CALIPER BRAKE
Release counter nut A and turn adjustment screw B counter clockwise until the
distance between brake pads and rims is approx. 2mm on each side. Tighten
counter nut A.
If the adjustment screw B is released
already to the limit, then release cable
clamping screw C and turn adjustment
screw clockwise to its original position.
Close the caliper brake with your hand
to the rim, adjust the brake cable and
tighten clamping screw C. Please note
the Tightening Torques table at the end
of this manual.
quick release
lever
centering adjustment bolt
3mm allenkey
closed
open
Finally make the fine tuning with adjustment screw B as mentioned above. The
wheel needs to spin free without touching the brake pads. Fix counter nut A.
IMPORTANT!
Make sure that the brake works perfectly.
IMPORTANT!
Under wet conditions the brake performance can decrease which will result in a
prolongation of the braking distance.
5mm allen key
tightening torque :
6‑8 Nm (52‑69 in. lbs.)
inner cable lead
Spring tension
adjustment screw
Spring tension
adjustment screw
Depress lever
about 10 times
V‑BRAKE
1. While holding the shoe against the rim,
tighten the shoe fixing nut.
2. Pass the inner cable through the inner
cable lead, and after setting so that the
total of the clearances between the left
and right shoes and the rim is 2 mm
tighten the cable fixing bolt.
3. Adjust the distance with the spring
tension adjustment screws.
4. Depress lever about 10 times
07 |
BIKE USER MANUAL | BMXBMX | BIKE USER MANUAL
| 06
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Scott BMX 2018 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Scott BMX 2018

Scott BMX 2018 Bedienungsanleitung - Deutsch - 10 seiten

Scott BMX 2018 Bedienungsanleitung - Französisch - 10 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info