Bedienungsanleitung Seiko 7B62 (Seite 21 von 21) (Englisch)

757413

Zoom out

Zoom in

Vorherige Seite

1/21

Nächste Seite

In case of an abnormal movement

In the case that the watch moves abnormally or that the watch does not move at one-second intervals even

after fully charging the battery, then it can be returned to normal operation using the following operation.

■ Reset the system

01 2

Pull out the

crown to the

second click

1Pull the crown to the second click.

The seconds hand stops on the spot.

* When the crown is a screw lock type, unlock it.

→ P.13

EN 76

TROUBLESHOOTING

Press and hold the

button for 5 seconds

and then release it

3When all the hands stop pointing to 12 o’clock 0 minutes and 0 seconds, push

the crown back.

The seconds hand starts moving from 12 o’clock 0 minutes and 0 seconds.

* After a system reset, the time difference setting is set to +9 hours (JJY).

After completion of a system reset, perform the following operations.

• “Set the preliminary position for the date, and the hour and minute hands.” → P.65

• “Setting the time difference (Setting the radio signal transmitting station)” → P.29

• “How to conduct manual reception (Receive a radio signal manually)” → P.56

* When the crown is a screw lock type, lock it. → P.13

2Press and hold the button for 5 seconds

and then release it.

After releasing the button, approximately 5 seconds

later the seconds hand moves, and stops at the

0-second position.

Then the hour and minute hands will start to move

and stop pointing to 12 o’clock 0 minutes.

* The button cannot be operated until all the hands stop.

EN 77

TROUBLESHOOTING

Specifications

Cal. 7B62 / 7B72

1. Features Basic watch with three hands (Hour, minute and seconds hands), date display

2. Frequency of crystal

oscillator

32,768 Hz (Hz= Hertz, cycles per second)

3. Loss/gain (Monthly

rate)

Loss/gain ±15 seconds in a monthly rate (Except the cases when the watch is used

without time adjustment by receiving a radio signal and when it is worn on the wrist within

a normal temperature range between 5 °C and 35 °C)

4. Operational

temperature range

Between −10 °C and +60 °C

5. Driving system Step motor (Hour and minute hands, seconds hand, and the date)

6. Power source Secondary battery, 1 piece

7. Duration Approximately 9 months (Fully charged, and the Power Save is not activated)

* If Power Save is activated after it is fully charged, the watch continues to run for approximately

2 years at maximum.

8. Radio signal reception

function / radio signal

transmitting station

Automatic reception (Before 2:00 AM, 3:00 AM and 4:00 AM)

* It varies depending on the radio signal receiving condition.

* After radio signal reception, the watch will start to work depending on the quartz movement

until the next reception.

* Manual reception is available.

9. Integrated circuit Oscillator, frequency divider, drive and reception circuit: IC, 2 pieces

* The specifications are subject to change without prior notice due to product improvements.

EN 78

SPECIFICATIONS

EN 80

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Seiko 7B62 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info