Selecttime Digital Plug in Time Switch
Time Display
To change from 12-hour display to 24-hour display, or vice versa, press the CLOCK button
and hold it until the LCD display changes.
Setting the day and time
Press and hold the SET Button until the day shown on the LCD flashes.
Press either the ▲ or ▼ button to select the correct day of the week.
NOTE: Holding down either the ▲ or ▼ button speeds up the selection process.
Press the SET Button again to confirm your selection.
The hour will now start flashing on the LCD. Repeat steps above to set the correct hour and
repeat again to select the correct minutes.
Setting the timer
With the timer on Clock mode, press the ▲ button once to change to Program mode. “1ON”
will be shown on the lower left corner of the LCD. This indicates that Program Block 1 out of
a possible 20 blocks is now selected and the switch ON time can be set.
NOTE: If the timer has been previously programmed the current setting will appear on the
LCD. You can re-set the Digital Timer at any stage by removing the battery.
Begin programming by pressing the SET button. The LCD will now show 12:00 or whatever
was previously set, and the day(s) of the week will be flashing.
The timer has pre-set days already programmed into it to make it easier to program and to
maximise the available program blocks.
Make your selection by pressing the ▲ button and the LCD will display the following in
sequence:
MO TU WE TH FR SA SU (all days of the week selected)
MO→TU→WE→TH→FR→SA→SU (select individual days)
MO WE FR (only Monday, Wednesday and Friday selected)
TU TH SA (only Tuesday, Thursday and Saturday selected)
SA SU (only Saturday and Sunday selected)
MO TU WE (only Monday, Tuesday and Wednesday selected)
TH FR SA (only Thursday, Friday and Saturday selected)
MO TU WE TH FR (everyday but Saturday and Sunday selected)
MO TU WE TH FR SA (everyday except for Sunday selected)
You can navigate through the selection sequence by using the▲ or ▼ buttons. Press the SET
button to confirm your selection.
