758520
20
Zoom out
Zoom in
Vorherige Seite
1/22
Nächste Seite
EN-20
EN
Food Processor
STM 40WH / STM 41GR / STM 42BL / STM 43OR
STM 44RD / STM 45VT / STM 46YL / STM 47GG / STM 48RS
2014
11/2014
Set the speed to 2 and gradually add the fl our until everything is properly combined into a single
mass. Do not, however, beat for too long.
Use a teaspoon to form small balls and lay them out evenly on to a lightly greased or parchment
paper covered baking tray. Leave suffi cient room around each ball. Using a lightly fl oured fork,
push down each of the balls.
Bake in a preheated oven at 190 °C for approximately 12-15 minutes or until the biscuits are lightly
golden in colour.
Take the biscuits off the baking tray and leave to cool down on a metal rack.
Cream snow puffs (20–24 pcs)
4 egg whites
1 cup of caster sugar
Use the whisk A2.
Set the speed level to 8 and whip up a thick snow from the egg whites. Lower the speed to level 1
and carefully add half the sugar and whip it in. Then add the remaining sugar.
Using a spoon, apply a small amount of the snowy mixture on to a lightly greased baking tray.
Leave about 3 cm around the individual pieces so that they do not bake to one another.
Bake in the oven at 120 °C about 1 to 1½ hours or until the snow puffs are dry. To avoid burning
them, do not, however, bake then too long. Take them off the baking tray and put them aside to
cool down and store them in an air-tight container.
Note:
You can use a decorating tool to create larger snow puffs. This may necessitate a longer baking
time.
White bread
4 cups (600 g) of bread fl our
3 tablespoons of dried milk
1½ teaspoons of salt
1½ tablespoons of sugar
1 teaspoon of bread improver
2 teaspoons of instant yeast
2 tablespoons of oil
1½ cups (375 ml) of water
additional bread fl our for hand kneading
Use the kneading hook A1.
In the mixing bowl, mix the fl our, dried milk, salt, sugar, bread improver and the instant yeast.
Set the speed to 1–2 and slowly add water and oil into the dry mix. Leave it to knead until a dough
starts to form.
Move the dough on to a lightly fl oured rolling board and thoroughly knead by hand until the
dough is suffi ciently fi ne and smooth.
Note:
At this stage, the dough should be very well kneaded so that gluten is formed, which gives the
dough the correct elasticity and helps it to rise.
Place the dough into a large bowl and cover with plastic wrap. Allow it to rise in a warm place for
about 20 minutes or until the dough doubles in size.
20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sencor STM 45 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info