Bedienungsanleitung Sencor SWK 1503 (Seite 7 von 8) (Englisch)

759024

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Electric Kettle

SWK 1501GR / SWK 1502BL / SWK 1503OR / SWK 1504RD / SWK 1505VT / SWK 1506YL / SWK 1507TQ

EN-7

2018 03/2018

BEFORE FIRST USE

1. Remove all wrapping material from the kettle and its base.

2. Fill the kettle with clean water up to the maximum water mark. Boil the water and empty the contents of the kettle.

Repeat this process 2 to 3 times.

Note:

To boil water in the kettle proceed according to the instructions in chapter Using the kettle.

3. Now the kettle is ready for use and for preparing warm beverages, etc.

U SING THE KETTLE

1. Set the desired length of the power cord. Push the power cord into the groove in the base. Place the base on

astable, even and clean surface.

2. Fill the kettle with the required amount of water. You may ﬁll the kettle through the spout or through the opening

after lifting the lid. To open the lid, press the safety lid lock A2 in the direction of the handle. The water level must

reach at least the minimum mark (0.5l) and must not exceed the maximum mark (1.5l).

Warning!

Never ﬁll the kettle if it is located on the base.

If the kettle is overﬁlled, then boiling water could splash out.

3. Place the kettle on the base. Insert the power plug into the an electrical power socket. Check that the lid of the

kettle is closed.

4. Start the kettle by moving the switch to position I(On). The power On light will illuminate.

Attention:

Do not turn on the kettle if it is empty. The incorrect use of the kettle may negatively affect its lifetime.

If you accidentally turn on the kettle without water, the thermostat will, after reaching acertain

temperature, interrupt the electric circuit and the power On light will turn off. The kettle can be used

again after several minutes, as soon as its stainless steel bottom has cooled down.

5. As soon as water boils the kettle will turn off automatically and the power On light will turn off. Before taking the

kettle off the base, check that it has turned itself off automatically. If it has not automatically turned itself off, turn

off the kettle manually by moving the switch to position 0 (Off).

Note:

The operation of the kettle can be interrupted at any time by moving the switch to position 0 (Off).

6. Pour the boiled water into aprepared container, cup or mug. Make sure that the kettle remains in ahorizontal

position when it is carried, particularly if it is ﬁlled all the way up the maximum mark. If you wish to open the lid to

reﬁll the kettle, ﬁrst empty all the contents from the kettle so that you are not scalded by the escaping steam.

7. After you ﬁnish using the kettle, disconnect the power cord from the el. power socket. Empty the kettle and allow

it to cool down.

CLEANING AND MAINTENANCE

Cleaning the ﬁlters

■The removable ﬁlter serves to capture scale deposits and prevent them from getting into the prepared beverage.

Regularly clean the ﬁlter under running water using aﬁne nylon brush or submerge it for several hours into avinegar-

water solution (recommended dilution ratio 1:2). After applying the solution rinse the ﬁlter under clean running water.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sencor SWK 1503 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info