Bedienungsanleitung Shark FM430 (Seite 1 von 2) (Englisch)

668675

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

Hand Vacuum With Motorized Brush

Style # XFH430

for Model FM430

HEPA Filter

3. Rotate the lower dust cup clockwise

to separate it from the filter chamber.

Empty and clean the dust cup. (See

illustration below.)

Filter

Chamber

Dust

Cup

Debris

Screen

7. “TapClean” the Debris

Screen or rinse under

a faucet until clean.

(See illustration at

right.) Remember that

the Debris Screen

must be completely

dry before reinstalling

in the vacuum.

8. Replace the Debris Screen on the

HEPA Dust Cup Filter and reinstall

filter assembly in the vacuum. (not

shown)

CAUTION: Be sure to turn the On/Off switch to the "OFF"

position and disconnect the power cord from

the wall outlet before cleaning the filters.

5. Separate the debris screen from the

HEPA filter cartridge by grasping the

debris screen with one hand and the

filter frame with the other and pull

apart. (See illustration below.)

Filter

Chamber

HEPA

Filter

Debris

Screen

6. Vigorously “TapClean”

the HEPA Dust Cup

Filter on a hard surface

until no more dust is

observed falling out

from between the

pleats of the filter. (See

illustration at right.)

CAUTION: The suction hole must be

open, free of any obstructions at all

times. Otherwise, the motor will overheat

and could become damaged.

PLEASE NOTE

: The white pleated

filter material in the HEPA Dust Cup

Filter will discolor over time -This is

NORMAL and will NOT affect the

performance of the filter. If the HEPA

Dust Cup Filter

is properly

"TapCleaned”

after each use

and suction

does not return

to 100%, then

we suggest that

the HEPA filter

be “TapCleaned”

vigorously until no

more dust can be removed, then

rinsed under the faucet and allowed to

dry for 24 hours before refitting into

the vacuum. (Fig. A) This should be

done once a month or when

suction appears reduced.

Fig. A

Wash once a

month or when

suction

appears

reduced.

Warning: Allow 24

hours for drying before

replacing in unit.

4. Remove the HEPA Filter from the filter

chamber. (See illustration below.)

Depending on usage and conditions, the HEPA filter lasts 3 to 6 months;

however, vacuuming large amounts of extremely fine dust, powder or

similar material over a long period of time may decrease airflow

performance through the filter. If this occurs, it may become necessary to

replace the HEPA Filter. Only use genuine FANTOM replacement filters.

Cleaning & Changing the HEPA Dust Cup Filter

Important: Do NOT use the HEPA filter

cartridge without the debris screen in

place.

1. To remove the dust cup (container),

hold the unit in the upright position

to prevent the dust from falling out

of the dust cup. (See illustration below.)

Warning: After each Use - Always

remove the Filter Debris Screen from the

HEPA Dust Cup Filter, then vigorously

“TapClean” HEPA Filter until no more

dust can be removed.

HEPA

Filter

IMPORTANT

, Please Note : The

“TapClean” HEPA Dust Cup Filter &

Debris Screen will stop most of the tiniest

dust particles from re-entering the air you

breathe. In fact it stops 99.97% of all

particles as small as 0.3 microns - many

times smaller than a human hair!!!

Because of this incredible filtration

performance, the HEPA Dust Cup Filter

will quickly accumulate, inside the white

filter folds, many fine dust particles that

are difficult to see but which will eventually

block or reduce your suction power - if not

cleaned properly. Clean the HEPA Filter

and Debris Screen after each use as

described in this section.

2. To open the Dust Cup (container),

push button and remove the Dust

Cup (container ). (See illustration

below.)

Dust cup release button

NOTE: DO NOT OPERATE VACUUM WITHOUT FILTERS IN PLACE.

FANTOM

94 Main Mill Street, Door 16

Plattsburgh, NY 12901

Tel.:

1 (800) 275-9251

www.fantom.com

Rev. 10/05

Printed in China

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Shark FM430 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Shark FM430

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info