668636
5
Zoom out
Zoom in
Vorherige Seite
1/11
Nächste Seite
4
TOLL FREE: 1-800-798-7398
5
www.SharkVacThenSteam.com
English
3 Place your foot lightly on the top
of the cleaning unit base. Tilt the
cleaning unit back. Vacuum your
floors.
IMPORTANT: Vacuum all surfaces
first before steam-cleaning to
avoid condensation build-up. Avoid
vacuuming after steam mopping.
NOTE: If you vacuum and then
steam-clean one room, before
moving on to the next, wait 10
minutes for the condensation to
clear before vacuuming again.
USING VACUUM MODE
1 Pull and twist the quick release cord
holder to unwrap the power cord
completely. Plug in the unit.
2 To vacuum, slide the toggle switch
until the vacuum power button is
exposed. Press the vacuum power
mode button to the ON I” position.
IMPORTANT: You cannot use the
vacuum function if the frame and
pad are attached to the base of the
cleaning unit.
NOTE: Only vacuum sealed and
non-carpeted bare floor surfaces.
Refer to floor manufacturer
guidelines and warnings.
Getting Started: Vacuum and Steam Panel Vacuum Mode
OPERATING IN VACUUM MODE:
1 Remove steam pad and frame,
if attached. See page 11 for
instructions. Vacuum will not activate
if steam frame is attached.
2 SLIDE THE TOGGLE SWITCH UP to
expose the vacuum power button.
3 Press the VACUUM POWER BUTTON
to the ONI” position to activate
the vacuum.
OPERATING IN STEAM MODE:
1 Attach steam pad and frame.
Steam mode will not work if the pad
and frame are NOT attached. See
page 8 for assembly instructions.
2 Fill the water tank.
SLIDE THE TOGGLE SWITCH DOWN
to expose the Steam Power button.
3 Press the STEAM POWER BUTTON
to the ONI position. The button
will be illuminated red when steam
mode is activated.
4 Wait 30 seconds to heat water, then
TILT HANDLE BACK TO ACTIVATE
STEAM PUMP.
The Vac-Then-Steam™ has two
operating modes:
After inserting the telescopic handle,
your cleaning system is vacuum-ready.
Begin vacuuming your hard-surface
floors by tilting the cleaning unit back
and pressing the vacuum power button.
2
3
1
1
1
2
2
3
3
VACUUM MODE:
STEAM MODE:
DO NOT USE STEAM PAD AND
FRAME IN VACUUM MODE
MV2010WC_11_IB_ENG_100803.indd 4-5 04/08/10 9:38 AM
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Shark MV2010WC wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info