Bedienungsanleitung Shark S3200 (Seite 8 von 8) (Englisch)

668649

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Using Your Steam Cleaner with

Steam Pocket™

Step 1. Attach one or both of the

extension tubes to the hand grip

of the flexible hose. To attach the

extension tubes one onto the

other or onto the hand grip, press

the locking button ensuring that it

fits into the hole (Fig. 3., Fig. 4)

and press the two sections

together.

Attaching the Steam Pocket™

Towel to the Frame

1. Slide the Steam

Pocket™ towel over

the steam pocket

frame. (Fig. 7)

2. Bring the towel all

the way to the top

of the steam

pocket frame.

(Fig. 8)

3. Bring the velcro

strips that are on the

back side of the

steam pocket™ towel

over the steam pocket

frame and attach to

the inside of the

front side of the

Steam Pocket™ towel.

(Fig. 9)

NOTE: If replacing the Steam

Pocket™ towel, make sure that the frame

has been allowed to cool before removing

or attaching a new Steam Pocket™ towel.

1. Slide the Steam

Pocket™ towel over

the steam pocket

frame. (Fig. 7)

2. Bring the towel all

the way to the top

of the steam

pocket frame.

(Fig. 8)

3. Bring the velcro

strips that are on the

back side of the

steam pocket™ towel

over the steam pocket

frame and attach to

the inside of the

front side of the

Steam Pocket™ towel.

(Fig. 9)

NOTE: If replacing the Steam

Pocket™ towel, make sure that the frame

has been allowed to cool before removing

or attaching a new Steam Pocket™ towel.

WARNING: Always insure the unit is

“UNPLUGGED” from the wall receptacle

prior to attaching or removing

accessories.

OPERATING INSTRUCTIONS

Fig. 4

Fig. 7

Fig. 6

Fig. 9

Note: The flat end on the angle

adapter must face toward the

side of the frame with the brass

pin. Once inserted, rotate it 90°

Step 4. Insert the electrical power cord

into the outlet. Heating time is

approximately 5 minutes

with cold water. Filling the

steam generator with hot water

will shorten the heat up time.

Fig. 6

Hand Grip

Locking Button

Fig. 3

Step 2. To attach the flexible hose to the

main unit, align the end of the

hose with the pins to the notches

in the nozzle of the unit. Push

the flexible hose into the nozzle

until it stops against the unit and

rotate 90˚ until it locks into

position. (Fig. 5) To remove

the flexible hose, push the

flexible hose in, rotate 90˚ in the

opposite direction and pull the

flexible hose out.

Fig. 5

Nylon Bristle Brush (x3)

It is best for cleaning grout in-between

the tiles, ceramic and marble.

To use: To attach the nylon

bristle brush to the concentrator

nozzle push on and turn to lock.

Squeegee Attachment

This attachment is very useful for cleaning

windows, ceramic, tiled or marble

surfaces.

IMPORTANT: When cleaning windows,

always avoid any sudden changes in

temperature to prevent glass breakage or

cracks.

To use: To attach the squeegee

attachment to the steam/garment diffuser,

place the two hinges at the back of the

squeegee attachment into the two open

tabs that are at the back of the

steam/garment diffuser. (Fig. 11)

Care & Maintenance of the Steam

Pocket™ Towel

• To clean the towel, simply wash it in your

washing machine using the warm water

setting.

• Always wash your towels separately

from other fabrics. They have a tendency

to pick up lint and other particles from

other fabrics and the next time you use

your towel, this lint will transfer to the

surface being cleaned.

• ONLY USE LIQUID DETERGENTS,

never use dry detergents as many times

the granules do not fully dissolve and

become trapped in the towel. This can

scratch the surface that you are

cleaning.

• NEVER USE BLEACH OR FABRIC

SOFTENERS! Bleach will damage the

micro-fiber fabric and fabric softeners

deposit a coating on the micro-fiber

fabric what will not allow the cloth to

clean efficiently.

• Air dry the towel. Do not put in a clothes

dryer as high heat will cause the towel to

shrink and the micro-fibers to break

down.

• If you wash your towel on a regular basis

and don’t let it get too dirty, it will last

much longer. As with any fabric, dirt

particles, grease and other contaminants

can cause the fibers to break down,

therefore regular cleaning will help

preserve your micro-fiber towel.

• As you use the micro-fiber towel, you will

notice that sometimes a thread will

loosen or pull out. This is normal and

you should NEVER PULL AT THE

LOOSE THREAD! Pulling the thread can

cause the weave to come undone.

Instead, simply trim the thread with a

pair of sharp scissors.

CAUTION: Be aware of hand placement

and take care not to actuate the steam

discharge switch while installing or

removing accessories.

OPERATING INSTRUCTIONS

Attaching the Accessories to the

Steam Unit

Always allow the unit to cool for 15

minutes before changing accessories.

Concentrator Nozzle or Steam/Garment

Diffuser

To attach the concentrator nozzle or the

steam/garment diffuser to the unit, align

the two pins on the end of the concentrator

nozzle or the steam/garment diffuser with

the notches in the nozzle of the unit.

Angled Concentrator

Use the extended concentrator

to clean under toilet rims

and hard to reach places.

To use: To attach the angled

concentrator to the concentrator

nozzle push on and turn to lock.

Fig. 11

Step 3: Attach the steam pocket frame

with the angle adapter onto the

extension tube.

Note: If the angle adapter is not

attached to the steam pocket

frame, attach as follows: Hold

the steam pocket frame in one

hand and the

angle adapter in the

other. Insert the

angle adapter

into the opening

of the steam

pocket frame as shown in

Fig. 6.

Due to the unique cleaning ability of this

cloth, proper care of your micro-fiber towel

is required to ensure long life and continued

cleaning ability.

• The first thing you should do when you

get a new micro-fiber towel is to wash and

dry it. During the manufacturing process

the fabric has a tendency to become flat

as it picks up contaminants from the air

and machinery. There will also be a

number of loose threads that, while they

cause no harm, can be annoying the first

time you use the towel.

Swing the squeegee attachment up

against the bottom of the steam/garment

diffuser until the locking tab engages. To

remove the squeegee attachment, just

push your thumb against the locking tab

to release.

Steam/Garment Diffuser Bonnet

To use the steam/garment diffuser bonnet

try on a hidden area first to test for color

fastness see “Spot Cleaning” in the “Tips”

section.

To use: Attach the steam garment/diffuser

bonnet over the steam/garment diffuser.

(Fig. 10)

Fig. 10

Shark S3200 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info