30711
20
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
20
EN
INFORMATION
Designs and specifications are subject to change without notice.
SPECIFICATIONS
TROUBLESHOOTING GUIDE
If this unit does not perform properly when operated as instructed in this Operation Manual, check this unit consulting the following checklist.
PROBLEM CORRECTIVE ACTION
No power. Make sure the power plug is connected to an AC outlet.
Make sure the power is turned on.
The unit turns off suddenly. • Check if the AUTO POWER OFF” is set to “OFF”.
This unit does not respond to the remote
control.
Check if the power plug is connected to an AC outlet.
Check the batteries in the remote control.
Aim the remote control directly at the remote sensor. If necessary, remove all the obstacles
between the sensor and the remote.
You have to be within 23 feet (7 m) of this unit.
No picture. Connect the video cable firmly.
Insert a correct video disc that plays on this unit.
Disc cannot be played. Insert the disc.
Clean the disc.
Insert the disc correctly with the label facing to the left when the unit is installed vertically.
Insert the disc correctly with the label facing up when the unit is installed horizontally.
Cancel the parental lock or change the control levels.
Handle a disc with special care so that it does not have fingerprints, scratches, or dusts on its surface.
If the recorded portion of the disc is too small (less than 2 3/16 inches (55 mm)), it may not play
back properly.
No sound. Connect the audio cable firmly.
Turn the power of the audio component on.
Correct the audio output settings.
Correct the input settings on the audio component.
No DTS audio is output. Use a DIGITAL AUDIO OUT jack when outputting the DTS audio.
Distorted picture. Connect this unit directly to the TV.
There are some cases where picture may be slightly distorted, and those are not a sign of a malfunction.
During the playback of a 2-layered disc, pictures may stop for a moment. This happens while the
1st layer is being switched to the 2nd layer. This is not a malfunction.
Check if the INTERLACE/PROGRESSIVE mode is set correctly according to your TV. See page 8.
This happens right after fast forwarding or rewinding. This is not a malfunction.
Audio or subtitle language does not
match the set up.
The selected language is not available for audio or subtitles on the DVD.
This is not a malfunction.
The camera angle cannot be changed. The DVD does not contain sequences recorded from different camera angles.
This is not a malfunction.
Audio or subtitle language cannot be
changed.
The DVD does not contain audio source or subtitles in the selected language.
This is not a malfunction.
“Prohibited icon” appears on the screen,
prohibiting an operation.
That operation is prohibited by this unit or the disc. This is not a malfunction.
Some functions are not available in specific modes, but this is not a malfunction. Read the description in this Operation Manual for details on correct operations.
Playback from a desired track and random playback are not available during programmed playback.
Some functions are prohibited on some discs.
SERVICE INFORMATION (FOR THE U.S.)
For the location of the nearest SHARP Authorized Service Center, or to obtain product literature, accessories, supplies or customer assistance,
please call 1-800-BE-SHARP (1-800-237-4277) or visit SHARP’s website (http://www.sharpusa.com).
PRODUCT TYPE
DVD Video Player
DISCS PLAYBACK COMPATIBILITY
DVD-Video / DVD-RW/-R / DVD+RW/+R / Audio CD / CD-RW/-R
FREQUENCY RESPONSE
DVD (linear sound) : 20 Hz to 22 kHz (sample rate: 48 kHz)
20 Hz to 44 kHz (sample rate: 96 kHz)
CD : 20 Hz to 20 kHz
SIGNALTONOISE RATIO S/N RATIO
CD : 120 dB (JEITA)
DYNAMIC RANGE
DVD (linear sound) : 102 dB
CD : 99 dB (JEITA)
TOTAL DISTORTION FACTOR
DVD : 1 KHz 0.0045% (JEITA)
CD : 1 KHz 0.0035% (JEITA)
WOW AND FLUTTER
Below the measurement limitation (+/-0.001% W PEAK) (JEITA)
CONNECTIONS
Video output One RCA connector, 1 Vpp (75 Ω)
Component video output One pin jack (Y), 1 Vpp (75 Ω)
Two pin jacks (C
R/PR, CB/PB),
700 mVpp (75 Ω)
S-video output Mini DIN 4-pin jack (75 Ω)
Analog audio output Two RCA connectors
(one left channel, one right channel)
2 Vrms (47 kΩ)
Coaxial digital audio output One pin jack, 500 mVpp (75 Ω)
POWER SOURCE
120 V ~ +/- 10%, 60 Hz +/- 0.5%
POWER CONSUMPTION
10 W (standby: 0.8 W)
OPERATING TEMPERATURE
41 F° to 104 F° (5 °C to 40 °C)
DIMENSIONS
W: 2.5 inch (62 mm) H: 9.8 inch (248.5 mm) D: 9.4 inch (238 mm)
WEIGHT
Approx 2.9 lbs. (1.3 kg)
E61U1UD_2.indd 20E61U1UD_2.indd 20 8/8/2005 11:53:16 AM8/8/2005 11:53:16 AM
20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sharp DVMX1U wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info