Bedienungsanleitung Sharp R-610D - Carousel (Seite 5 von 20) (Englisch)

611274

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

A35611,SEC R610DKA/SA/WA O/M

TINSEB005WRRZ-D31 SEC R610D

This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a ground-

ing plug. It must be plugged into a wall receptacle that is properly installed and grounded in accordance with

the National Electrical Code and local codes and ordinances. In the event of an electrical short circuit,

grounding reduces risk of electric shock by providing an escape wire for the electric current.

WARNING – Improper use of the grounding plug can result in a risk of electric shock.

Electrical Requirements

The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more

protected electrical supply. It is recommended that a separate circuit serv-

ing only this appliance be provided.

The oven is equipped with a 3-prong grounding plug. It must be plugged into a

wall receptacle that is properly installed and grounded. Should you only have a

2-prong outlet, have a qualified electrician install a correct wall receptacle.

A 3-prong adapter may be purchased and used temporarily if local codes

allow. Follow package directions.

A short power-supply cord is provided to reduce risk of becoming entangled

in or tripping over a longer cord.

Extension Cord

If it is necessary to use an extension cord, use only a 3-wire extension cord

that has a 3-blade grounding plug and a 3-slot receptacle that will accept

the plug on the microwave oven. The marked rating of the extension cord

should be AC 115-120 volt, 15 amp. or more.

Be careful not to drape the cord over the countertop or table where it can be

pulled on by children or tripped over accidentally.

Notes:1. If you have any questions about the grounding or electrical in-

structions, consult a qualified electrician or service person.

2. Neither Sharp nor the dealer can accept any liability for damage

to the oven or personal injury resulting from failure to observe the

correct electrical connection procedures.

Radio or TV Interference

Should there be any interference caused by the microwave oven to your radio or TV, check that the

microwave oven is on a different electrical circuit, relocate the radio or TV as far away from the oven as

feasible or check position and signal of receiving antenna.

GROUNDING INSTRUCTIONS

Unpacking and Examining Your Oven

Remove:

1. all packing materials from inside the oven cav-

ity; however, DO NOT REMOVE THE

WAVEGUIDE COVER, which is located on the

right cavity wall. Read

enclosures and SAVE

the Operation Manual.

2. the feature sticker, if

there is one, from the

outside of the door.

Check the oven for any

damage, such as mis-

aligned or bent door,

damaged door seals and sealing surfaces, bro-

ken or loose door hinges and latches and dents

inside the cavity or on the door. If there is any

damage, do not operate the oven and contact your

dealer or SHARP AUTHORIZED SERVICER.

Choosing a Location for Your Oven

You will use the oven frequently so plan its loca-

UNPACKING AND INSTALLATION INSTRUCTIONS

tion for ease of use. It's wise, if possible, to have

counter space on at least one side of the oven.

Allow at least 2 inches on the sides, top and at

the rear of the oven for air circulation. Do not place

or install the oven in any area where heat and

steam are generated; for example, next to or

above a conventional gas or electric range or

above a conventional wall oven. Heat and steam

may damage the electronics or the mechanical

parts of the oven.

Built-in Kit

Your oven can be built into a cabinet or wall—not

near or above a heat source—using one of Sharp’s

Built-in Kits, either the RK6S24 (silver) or the

RK6K24 (black). The RK6S24 can be used with

either the R-610DSA or the R-610DWA. The

RK6K24 can be used with the R-610DKA. If your

dealer does not stock the kit, order directly by call-

ing 1-800-642-2122 to have it sent to your address.

The kit includes ducts and finish trim strips and

easy-to-follow instructions for installation as well

as the location of the power supply.

R610DKA/SA/WA O/M,P01-10,COVER 03.6.10, 9:00 PM3

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sharp R-610D - Carousel Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info