465406
11
Zoom out
Zoom in
Vorherige Seite
1/14
Nächste Seite
11 / 14
Siemens REV24.. room temperature controller CE1N2205en
Building Technologies 24.04.2008
Reset
User-defined settings:
Press
, and simultaneously for 3 seconds:
This resets all temperature and time settings of the program selection slider to default
values (see also "Factory settings" in the operating instructions). The expert settings
remain unchanged.
The clock starts at 12 p.m., the date on 01-01-08 (01 January 2008).
During the reset, all display fields are lit and can be checked accordingly.
All user-defined settings plus expert settings:
Press the DIP switch reset button
ON
1 342
2211Z32
567 89
, and simultaneously for 5
seconds:
After the reset, all factor settings are reloaded. This applies to the program selection
slider as well as to the expert settings.
Engineering
Mount the room temperature controller in the main living room
Select the mounting place so that the sensor can acquire the air temperature in the
room as accurately as possible and without being influenced by solar radiation or
other heat or refrigeration sources
Mounting height is approx. 1.5 m above the floor
You can mount the unit on most commercially available recessed conduit boxes or
directly on the wall
Begin installation by first attaching and wiring the base. You can mount the base on
most commercially available recessed conduit boxes or directly on the wall. Then
insert the controller from top to bottom into the base.
For more information, see the installation instructions supplied with the unit.
Comply with all local regulations on electrical installation
Wire separately the remote control contact T1 / T2 using a separate, shielded cable
Remove from the batteries the battery transit tab designed to prevent premature
activation of the unit: Select desired language by
or . Confirm by .
You can change the control characteristics using the DIP switch on the rear of the unit
Set any thermostatic radiator valves to their fully open position, if present in the
reference room
Recalibrate the temperature sensor (see "Sensor calibration") if the displayed room
temperature does not match the room temperature measured
This is a software class A controller designed for use at a normal degree of pollution.
Mounting and
installation
Commissioning
Notes
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

siemens-rev24

Suche zurücksetzen

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Siemens REV24 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Siemens REV24

Siemens REV24 Bedienungsanleitung - Deutsch - 2 seiten

Siemens REV24 Bedienungsanleitung - Holländisch - 2 seiten

Siemens REV24 Bedienungsanleitung - Französisch - 2 seiten

Siemens REV24 Installationsanweisung - Alle Sprachen - 50 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info