Bedienungsanleitung Sigma 70-200mm f2.8 APO EX DG Macro MKII (Seite 1 von 1) (Englisch)

616755

Zoom out

Zoom in

Vorherige Seite

1/1

Nächste Seite

Thank you very much for purchasing a Sigma Lens. In order to get the maximum

performance and enjoyment out of your Sigma lens, please read this instruction booklet

thoroughly before you start to use the lens.

DESCRIPTION OF THE PARTS (fig.1)

NIKON AF TYPE CAMERAS

This lens functions in the same way as a G Type auto-focus Nikon lens (without an aperture

ring). Functions may be restricted depending on the lens/camera combination. For more

details, please refer to the camera’s instruction manual.

ATTACHING TO CAMERA BODY

When this lens is attached to the camera body it will automatically function in the same way

as the camera manufacturer’s lens. Please refer to the instruction booklet for your camera

body.

◆ On the lens mount surface, there are a number of couplers and electrical contacts.

Please keep them clean to ensure proper connection.

◆ While changing the lens, be sure to place it front end down to avoid damaging the rear

mount.

SETTING THE EXPOSURE MODE

The Sigma lens functions automatically once attached to the camera. Please refer to the

camera instruction book.

FOCUSING AND ZOOMING

This lens features Sigma’s built-in Hyper Sonic Motor (HSM). The HSM enables quick and

quiet autofocusing. For autofocus operation, set the focus mode switch on the lens to “AF”

position (fig.2) (Select the autofocus mode on your camera body for Nikon AF). If you wish

to focus manually, set the focus mode switch on the lens to the “MF” position (for Nikon AF,

select the manual focus mode on your camera body as you would do normally). Manual

focus can be achieved by turning the focus ring.

◆ This lens also permits manual focusing even in the autofocus mode. With the camera

set to the One-Shot AF (AF-S) mode, it is possible to manually override the autofocus

while the shutter release button is pressed halfway.

◆ The viewfinders of some Nikon AF cameras have indicators to display the focus status.

The “● ” symbol indicates that correct focus has been set, “

► ” indicates that focus is

set in front of the subject, and “

◄” indicates that focus is set behind the subject. When

this AF lens is used with Nikon AF cameras in MF mode, please adjust the lens’ focus

until the “● ” symbol is visible.

◆ When operating this lens in manual focus mode, it is recommended that correct focus be

confirmed visually in the viewfinder rather than relying on the distance scale. This is

due to possible focus shift resulting from extreme changes in temperature which cause

various components in the lens to expand and contract. Special allowance is made for

this at the infinity setting.

《Zooming》

Rotate the Rubber grip on the zoom ring to the desired position.

TRIPOD SOCKET AND COLLAR

This lens has a detachable tripod socket. When the locking knob on the collar is loosened,

the lens and camera can rotate freely to easily position the camera horizontally or vertically

(fig. 3).

To remove the tripod collar from the lens, first loosen and then disengage the locking knob.

(fig. 4)

FLASH PHOTOGRAPHY

The camera’s built-in flash will cause barrel shadow if used with this lens. For best results,

please only use an external flash unit.

DEPTH OF FIELD SCALE

The depth of field scale helps you to check the depth of field (the zone of sharpness) of

your composition. For example in figure (5), the depth of field zone is shown when the

aperture F16 is used.

◆ The depth of field scale can be used at a focal length of 70mm only.

ABOUT TELE CONVERTERS

The lens can be used with Sigma’s 1.4x EX or 2.0x EX Apo Tele Converters (optional),

becoming a 98-280mmF4 Autofocus telephoto zoom lens or a 140-400mm F5.6 Autofocus

telephoto zoom lens respectively.

◆ Do not use other manufacturers’ teleconverter’s, only those listed above are compatible.

◆ We recommend the DG APO Tele-Converters when using with DSLR cameras.

LENS HOOD

A bayonet type detachable `hood is provided with the lens. This lens hood helps to

prevent flare and ghosted images caused by extraneous light. Attach the hood and turn

clockwise until it stops rotating. (fig.6)

◆ In order to place the lens and hood into the storage case, you must first remove the

hood, then replace it on the lens in the reverse position. (fig.7)

FILTER

◆ Only one filter should be used at a time. Two or more filters and/or special, thicker

filters, such as a polarizing filter, may cause vignetting.

◆ When using a polarizing filter with an AF camera, use the “circular” type.

BASIC CARE AND STORAGE

◆ Avoid any shocks or exposure to extreme high or low temperatures or to humidity.

◆ For extended storage, choose a cool and dry place, preferably with good ventilation. To

avoid damage to the lens coating, keep away from mothballs or naphthalene gas.

◆ Do not use thinner, benzine or other organic cleaning agents to remove dirt or finger

prints from the lens elements. Clean by using a soft, moistened lens cloth or lens

tissue.

◆ This lens is not waterproof. When using the lens in the rain or near water, prevent it

from getting wet. It is often impractical to repair the internal mechanism, lens elements

and electric components damaged by water.

◆ Sudden temperature changes may cause condensation or fog to appear on the surface

of the lens. When entering a warm room from the cold outdoors, it is advisable to keep

the lens in the case until the temperature of the lens approaches room temperature.

TECHNICAL SPECIFICATIONS

Lens construction 15 – 18

Angle of View 34.3 – 12.3°

Minimum Aperture 22

Minimum Focusing Distance 1m (3.28 ft)

Magnification 1:3.5

Filter Size 77mm

Dimensions Dia.×Length 86.6×184.4mm (3.41×7.26 in)

Weight 1345g (47.4 oz)

Dimensions and weight include the SIGMA mount.

The CE Mark is a Directive conformity mark of the European

Community (EC).

SIGMA (Deutschland) GmbH Carl-Zeiss-Str. 10/2, D-63322 Rödermark, F.R.GERMANY

Verkauf: 01805-90 90 85-0 Service: 01805-90 90 85-85 Fax: 01805-90 90 85-35

ENGLISH

 Tripod Socket

 Lens Hood

 Filter Attachment Thread

 Focus Ring

 Distance Scale

 Focus Index Line

 Zoom Ring

 Focus Mode Switch

(Sigma SA and Canon AF only)

 Mount

Sigma 70-200mm f2.8 APO EX DG Macro MKII Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info