Bedienungsanleitung Silvercrest SRNH 100 A2 - IAN 75924 (Seite 33 von 37) (Deutsch, Englisch, Holländisch, Französisch)

658889

Zoom out

Zoom in

Vorherige Seite

1/37

Nächste Seite

33 GB

Important safety instructions / Safety system / Preparing the product for use

· only connect the heating pad to the voltage

indicated on the heating pad (label),

· only use the heating pad in conjunction with

the control unit

indicated on the heating

pad (label),

· do not operate the heating pad without su-

pervision,

do not switch the heating pad on if

it is folded or bunched up,

· do not cause any sharp creases in the heating

pad,

· do not place any objects, e.g. suitcase or

washing basket, on the heating pad when it is

switched on,

· do not place any sources of heat, e.g. hot wa-

ter bottle or similar, on the heating pad when

it is switched on.

These may all damage the heating pad.

Do not cover the control

and do not place it

on the heating pad when the pad is in operation.

The electronic components in the control

the heating pad cause the control

to heat

up slightly during operation.

Do not pull, twist or crease the cables. The

heating pad may otherwise be damaged.

Safety system

Note: the heating pad is equipped with a safety

system. The electronic sensor technology prevents

the entire surface of the heating pad from overheat-

ing by automatically switching oﬀ in the event of a

fault. If the safety system switches the heating pad

oﬀ automatically due to a fault, then the function

display

on the control unit

is no longer illu-

minated, even if the heating pad is switched on.

Please note that, for safety reasons, the heating

pad must not be used after a fault and must be

returned to the service address indicated.

Preparing the product for use

Note: the heating pad may smell of plastic the

ﬁrst time you use it, but this will disappear after a

short period of time.

To begin, ﬁrst connect the control

to the

heating pad with the plug-in connector

(see ﬁg. B).

Position the heating pad on your back so that

the fastener for the neck section is in the throat

area.

Then close the fastener.

Then adjust the length of the belt around your

stomach and ﬁt the two ends of the connector

together (see Fig. C) to fasten the belt.

To open the belt, press the two catches on the

connector at the same time (see Fig. C).

Switching on / oﬀ /

Selecting the temperature

Switching on:

Set Level 1, 2, 3, 4, 5 or 6 on the control

switch the heating pad on.

Note: The function display

illuminates after the

heating pad is switched on.

Note: this heating pad features rapid heating,

which allows it to heat up within the ﬁrst 10 minutes

of operation.

Switching off:

Set Level 0 on the control

to switch the

heating pad oﬀ.

Note: the function display

ceases to illumi-

nate.

Selecting the temperature:

Just before using the heating pad, set it to the

highest temperature setting (level 6). This will

cause the heating pad to warm up quickly.

If you wish to leave the heated pad on for sev-

eral hours, set the lowest temperature (level 1).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest SRNH 100 A2 - IAN 75924 Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info