Note: It is always recommended to use high quality audio leads for the connections.
Controls and operation:
After switching the amplifier on, you can select the required audio source via the buttons AC-3/ VCD/ CD and
AUX (23-26). The names of these buttons are the same as those of the inputs on the rear panel. If you press
the button AUTO (3, the amplifier switches automatically over to the input signal.
The volume is set via the volume control (6). The high and low frequencies are set via the buttons + and –
(27 & 28). The balance between left and right is set via the buttons L and R (29). If you want to mute the
sound up to zero, press the MUTE button (2). You can switch the loudness on and off via the LOUD button.
This option ensures a better balance between the various tones.
Depending on the number of boxes that you have connected and your personal taste, you can select the
boxes you wish to use via the buttons 2CH / 3CH and 5CH (15). In all cases, if you have connected a
subwoofer, this will always be active.
The volume of the subwoofer channel, the two rear speakers and the centre speaker can be set via the +
and – buttons (11 – 14). To make use of the pre-programmed settings, you can press one of the DSP
buttons (10).
If you wish to use one (or two) microphone(s), connect them to the 6.35mm jack sockets (7 & 8) on the front
panel of the amplifier. Set the volume of the microphone via the button MIC. VOL (5). The high frequencies
(20), the low frequencies (21) and the echo (19) are controlled via the buttons + and -. Press SPEECH (4) to
change the tone of the voice. Set the delay to the required number of milliseconds 24 / 48 / 72 or 96. Press
the button OK (22) to determine if you want to hear the sound from the microphone or not
All information re the settings and selections is clearly displayed on (9). Press the MODE button (16) to
display the sound level on the VU-meters.
Layout:
Front panel
1. POWER On/Off switch
2. MUTE Temporary sound cut
3. AUTO Automatic search for the connected audio source
4. SPEECH Tone control fro voice
5. MIC. VOL Microphone volume
6. MASTER VOLUME General volume
7. MIC 1 6.35 mm microphone jack (1)
8. MIC 2 6.35 mm microphone (2)
9. DISPLAY Displays all information
10. DSP Selection among 8 pre-programmed DSP settings
(speaker settings, equalizer, etc.)
11. SW. VOL Individual volume control for the subwoofer
12. SL. VOL Individual volume control for left rear speaker
13. CEN. VOL Individual volume control for centre speaker
14. SR. VOL Individual volume control for right rear speaker
15. 2/3/5 CH Selection of the (connected) speakers
16. MODE Selection among various display modes of the VU-meters
17. 24/48/72/96 ms Microphone delay
18. LOUD Loudness on/off
19. ECHO Echo setting for the microphone
20. M. TRE High frequency setting for the microphone sound
21. M. BASS Low frequency setting for the microphone sound
22. OK Microphone sound on/off
23. AC-3 Select audio source AC-3
24. VCD Select audio source VCD
25. CD Select audio source CD
