Bedienungsanleitung Smeg 43CT1 (Seite 13 von 14) (Englisch)

24318

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

2.- Clean the COMPARTMENTS of the

DRAWER using a brush and warm

water.

3.- Clean the siphons of the liquid com-

partments also.

After this is done, put the drawer back into

the washing machine.

Troubleshooting guide

Should anything go wrong with the functio-

ning of the washing machine, you can pro-

bably put it right by referring to the follo-

wing advice.

However, should the problem persist,

unplug the washing machine and contact

our TECHNICAL ASSISTANCE SERVICE.

There are no fuses or analogue compo-

nents which can be changed by the user.

But we urge you that under no circumstan-

ces should you attempt to open up the

machine.

The washing machine won’t start

– There is no electricity

– The washing machine is not plugged in

at the mains.

– The fuses on the fuse board have

blown.

– The loading door has not been closed

correctly.

– The Start button has not been pushed

in.

The washing machine does not take in

water

– The water has been cut off.

– he water inlet tap has not been turned

on.

– The hose filter is blocked.

– The water inlet pipe is tangled.

The washing machine will neither

release the water nor spin dry

– The water drain pipe is tangled.

The washing machine vibrates or makes

excessive noise

– The INTERIOR FASTENING SCREWS

have not been taken out.

– The washing machine is not on a level

surface. (Consult the Installation

manual).

Important:

Some models (high speed spin dry) have a

safety device incorporated into their spin

dry programmes which means that the

programme will stop should the garments

inside the drum concentrate in such a way

as to create an excessive level of vibrations.

Should you ever find that the garments are

not sufficiently wrung out, try spin drying

them once more after you have distributed

them more evenly inside the drum.

Drying instructions

The drying system

The drying process occurs due to hot air

circulating in a closed circuit and steam

condensing by means of refrigeration with

mains water.

Therefore IT IS ABSOLUTELY IMPERATIVE

FOR THE MAINS WATER TAP TO BE TUR-

NED ON DURING THE DRYING CYCLES

ALSO.

The water drainage pump will simultane-

ously switch on at regular intervals during

the whole drying programme in order to

release the refrigeration water in addition

to the water coming from the condensation.

During the last few minutes of the drying

cycle, there is no heating up of circulating

air. This is in order to even out the tempe-

ratures inside the drum so that no creases

should form. You are strongly recommen-

ded NOT TO INTERRUPT THIS FINAL

STAGE.

Preparing the garments

Check the manufacturer’s instructions on

all garment labels and make sure that they

can be machine dried. Do not machine dry

any excessively delicate items such as cur-

ENGLISH

LJ6A017N5 11/10/01 16:29 Página 71

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Smeg 43CT1 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Smeg 43CT1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info