655956
74
Zoom out
Zoom in
Vorherige Seite
1/160
Nächste Seite
Operating and maintenance notes
ENGLISH 34
x Check ignition cable (c) for proper connection and intact insulation. If the insulation is damaged, do not
continue work, but order repair from a specialist workshop authorised by us.
x Screw in spark plug (d) again. Torque: 25 Nm [18.4 ft·lbf]
x Push the spark plug connector (b) onto the spark plug (d) firmly at reattachment.
x Re-install the spark plug cover (8).
Danger of contamination of ribbed belt, associated carrier structure and coupling!
Only open the ribbed belt cover and coupling cover in a clean environment.
x Switch off the engine and turn the stop dial to "0".
Switching off the engine: Î Chap. 6.2, page 24
x Shut off water supply to the power tool.
x Put the power tool on level ground.
x Loosen both attachment nuts (a) of the ribbed
belt cover (14).
x Turn ribbed belt tension screw (13) towards the
left, e.g. counter-clockwise, to reduce the ribbed
belt tension).
Turn until the square nut (b) has been moved
towards the mark "" (c) as far as possible.
When installing the cutting device in the centre
position (cf. figure), the square nut is all the way
to the left; in case of installation in the outer
position, it is located all the way to the right.
x Remove both attachment nuts (a) entirely.
x Remove the ribbed belt cover (14).
x Screw the attachment nuts (a) of the ribbed belt
cover (14) onto the associated screws again and
tighten only slightly so that the separating device
cannot fall off again.
x Loosen all 3 attachment screws (d) of the
coupling cover (e).
The screws only need to be loosened until they
can be turned very easily. It is not necessary to
turn out the screws entirely, since the screws
should remain in the cover.
x Put the valve lever (28) for the water supply
parallel to the connection piece so that it does
not interfere with the following work step.
8.6 Ribbed belt replacement
14
b
a
13
c
74

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Solo 879-12 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info