680560
31
Zoom out
Zoom in
Vorherige Seite
1/31
Nächste Seite
Troubleshooting
– 31
Malfunction Possible causes Corrective action
Drive does not close the door. Photo eyes power supply interrupted. Check connection.
Replace fuse.
Drive has been disconnected from
mains power supply.
The drive always opens the door completely upon rst command
after the power supply has been restored.
Drive opens the door and then does not
respond to a command from the remote
control or the button.
Safety input tripped (e.g. photo eyes
defective).
Remove obstacle from photo eyes.
Repair photo eyes.
Direct connector not properly plugged in.
"Door CLOSE" end switch in the
carriage defective.
Replace end switch.
Automatic closing function active. Wait until the automatic closing function closes the door.
Deactivate automatic closing function (refer to chapter "Functions
and connections - automatic closing function (DIP 7 + 8)”.
Set stay open time of automatic closing function (see TorMinal
manual).
Drive closes the door and then does not
respond to a command from the hand-
held remote control or the button.
"Door OPEN" end switch in the
carriage defective.
Replace end switch.
No light at connected warning light. Defective fuse. Replace fuse; see chapter "Maintenance and care - replace fuse
(warning light connection)".
Defective bulb. Replace light bulb of warning light.
Speed varies during opening and closing.
Drive starts slowly and then accelerates.
Soft running, completely normal.
Chain rail dirty. Clean the rail and lubricate again; see chapter "Care and
maintenance - cleaning chains and drive unit rail".
Chain rail lubricated with incorrect
oil type.
Clean the rail and lubricate again; see chapter "Care and
maintenance - cleaning chains and drive unit rail".
Chain tightened incorrectly. Tighten the chain; see chapter "Installation - pre-installation of
installation variant".
Drive does not end programming
procedure.
End positions incorrectly adjusted. Adjusted end positions; see chapter "Commissioning - adjusting
the door Closed + Open end positions".
Door cannot be operated unless the
user presses and holds the buttons,
e.g. key switches.
Drive is in dead man operation.
Safety input tripped (e.g. photo eyes
defective).
Remove obstacle from photo eyes.
Repair photo eyes.
Direct connector not properly plugged in.
Drive has not been programmed,
no force values stored.
Program the drive. See chapter "Commissioning - programming
the drive".
Radio receiver only!
All LEDs ashing.
All memory locations occupied,
max. 112.
Delete any hand-held remote controls that are no longer needed.
Install additional radio receivers.
LED 3.1 or 3.2 lights up constantly. The radio signal is being received;
the button of a hand-held remote
control might be defective or an
external signal is present.
Remove the battery from the hand-held transmitter.
Wait until the external signal falls off.
LED 3.1 or 3.2 lights up. The radio receiver is in the Learning
mode and awaiting a radio code from
a hand-held remote control.
Press the desired hand-held transmitter button.
31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sommer Duo rapido 650 plus wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Sommer Duo rapido 650 plus

Sommer Duo rapido 650 plus Bedienungsanleitung und Installationsanweisung - Deutsch - 31 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info