Preparations of Installation
4
Safety instructions
The power cable supplied with the control unit may only be
used for the installation of the drive systems. After completion
of the installation, disconnect the cable and replace it with a
duct-laid cable. It is forbidden to use the supplied power cable
for standard operation of the gate.
• The control unit may only be connected to the power supply by a quali-
fied electrician.
• Always comply with the instructions in this manual.
• Locking devices (electrical keys, locking bolts, etc.) must be removed and
disabled prior to installation of the dive system.
• Ensure that the gate wings are properly secured to the posts as consid-
erable forces are applied to the devices during opening and closing of
the gate.
• Prior to welding of fittings to posts or gate wings, remove or cover the
drive unit to prevent damage from sparks, etc.
• If the gate is operated by means of a switch, it must be installed at a
minimum height of 1.6 m above ground to prevent inadvertent activation
by children.
• In public areas, use only approved fittings and securing devices (e.g.
dowels).
Tools required
Supplied Components
• Prior to installation, check delivery to ensure that it contains all neces-
sary parts.
• Depending on the design of your drive system, the delivery might deviate
from the standard delivery.
Complete installation kit 1 wing 2 wing
Weight 9.1 13.8 kg
Packaging (L x W x H): 800 x 200 x 220 mm
Installation and operating instructions 1 x 1 x
Drive unit including cables 1 x 2 x
Control system, in housing 1 x 1 x
(with radio receiver, transformer and mains plug)
Remote control device including battery 1 x 1 x
Gate wing fittings 1 x 2 x
Post fittings 1 x 2 x
M10x45 stainless steel hexagon screw 2 x 4 x
M10 stainless steel locking nut 2 x 4 x
Plug 2 x 4 x
