771699
2
Zoom out
Zoom in
Vorherige Seite
1/2
Nächste Seite
Setting the Audio Switch:
Top - OFF
Bottom - ON
Located on the DB100 Signaler (larger unit):
The speaker switch allows you to turn the Audio Alarm ON or
OFF. ON is down and OFF is up.
Multi-Function Input Jack:
Located on the right side of the DB Sensor, this input jack is
for installations as shown below in diagram 2 & 3.
DB100 INSTALLATION DIAGRAMS
Battery free installation (diagram 3):
Use wire provided, plug into jack outlet on side of
Transmitter. Remove chime cover and connect the red
and yellow wires to chime box terminal screws common
and front.
Troubleshooting & Help:
If you’ve followed the directions and are still having problems
please try the following suggestions:
1) Check battery in the sensor. Must be a 12-volt alkaline type.
2) Check dip switch settings. Both the sensor and the signaler
must match as shown in figure 1.1 above.
3) Check outlet for power.
4) Move the Signaler to an outlet closer to the sensor unit.
5) If using the Multi-Function input jack make sure that the wires
are not touching each other. See diagram number 2 & 3 for
proper installation.
6) Check that sensor is not further than 50 feet from the receiver.
7) Do not place sensor on steel doors or steel door frames.
For Technical help call 1-248-577-5400
M-F 8:00 a.m. – 5:00 p.m. Eastern Time
Or e-mail us with your questions at sonic-info@sonicalert.com
Warranty:
Thank you for purchasing this high quality Sonic Alert product. We hope you
will have many years of satisfied use. This Sonic Alert product comes with a
limited 5-year warranty so please retain your receipt in a safe place for possible
future reference; you will need in the event of warranty service.
Sonic Alert, Inc.
1050 East Maple Rd.
Troy, MI 48083
V/TTY 1-248-577-5400 fax 248-577-5433
E-mail: sonic-info@sonicalert.com
Web Site: www.SonicAlert.com
REV 1.5 (2008)
This device complies with Part 15 of the FCC Rules and with RSS-210
of Industry Canada. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
WARNING: Changes or modifications not expressively
approved by the party responsible for compliance could void
user’s authority to operate the equipment.
2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sonic Alert DB100 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info