Bedienungsanleitung Sony hs 75 (Seite 18 von 20) (Englisch)

213207

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Trouble symptoms and remedies

If a problem is caused by the connected computer or other equipment, please refer to the connected equipment’s instruction manual.

Symptom Check these items

No picture

If the 1 (power) indicator is not lit,

or if the 1 (power) indicator will not

light up when the 1 (power) switch

is pressed,

• Check that the power cord is properly connected.

If CABLE DISCONNECTED

appears on the screen,

• Check that the video signal cable is properly connected and all plugs are firmly seated in

their sockets (page 7).

• Check that the video input connector’s pins are not bent or pushed in.

• A non-supplied video signal cable is connected. If you connect a non-supplied video

signal cable, CABLE DISCONNECTED may appear on the screen before entering the

power saving mode. This is not a malfunction.

If NO INPUT SIGNAL appears on

the screen, or the 1 (power)

indicator is orange,

• Check that the video signal cable is properly connected and all plugs are firmly seated in

their sockets (page 7).

• Check that the video input connector’s pins are not bent or pushed in.

x Problems caused by a computer or other equipment connected, and not

caused by the monitor

• The computer is in the power saving mode. Try pressing any key on the keyboard or

moving the mouse.

• Check that your graphics board is installed properly.

• Check that the computer’s power is on.

• Restart the computer.

If OUT OF RANGE appears on the

screen,

x Problems caused by a computer or other equipment connected, and not

caused by the monitor

• Check that the video frequency range is within that specified for the monitor. If you

replaced an old monitor with this monitor, reconnect the old monitor and adjust the

computer’s graphics board within the following ranges:

Horizontal: 28–80 kHz

Vertical: 48–75 Hz

Resolution: 1280 × 1024 or less

If you are using Windows and

replaced an old monitor with this

monitor,

• If you replaced an old monitor with this monitor, reconnect the old monitor and do the

following. Select “SONY” from the “Manufacturers” list and select “SDM-HS75” or

“SDM-HS95” from the “Models” list in the Windows device selection screen. If the

model name of this monitor does not appear in the “Models” list, try “Plug & Play.”

If using a Macintosh system, • If you use the Macintosh adapter (not supplied), check that the Macintosh adapter and the

video signal cable are properly connected (page 7).

Picture flickers, bounces,

oscillates, or is scrambled

• Adjust the pitch and phase (page 12).

• Try plugging the monitor into a different AC outlet, preferably on a different circuit.

x Problems caused by a computer or other equipment connected, and not

caused by the monitor

• Check your graphics board manual for the proper monitor setting.

• Confirm that the graphics mode (VESA, Macintosh 19" Color, etc.) and the frequency of

the input signal are supported by this monitor. Even if the frequency is within the proper

range, some graphics boards may have a sync pulse that is too narrow for the monitor to

sync correctly.

• Adjust the computer’s refresh rate (vertical frequency) to obtain the best possible picture.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony hs 75 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony hs 75

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info