28640
44
Zoom out
Zoom in
Vorherige Seite
1/148
Nächste Seite
44 (GB)
Troubleshooting
Others
Symptom
Cause
Remedy
The LAMP/COVER indicator
flashes.
The lamp cover or the air filter is
detached.
Attach the lamp cover or the air filter securely
(see
pages 41 (GB) and 42 (GB)).
The LAMP/COVER indicator
lights up.
The lamp has reached the end of its life. Replace the lamp
(see pages 41 (GB) and 42
(GB)).
The lamp has reached too a high
temperature.
The TEMP/FAN indicator
flashes.
The fan is broken.
Consult with qualified Sony personnel.
The TEMP/FAN indicator
lights up.
The internal temperature is unusually
high.
Check to see if nothing is blocking the ventilation
holes.
Check to see if the air filter is clogged with dust.
(Do not use an air filter for more than 500 hours.)
Warning messages
Use the list below to check the meaning of the messages displayed on the screen.
Message Meaning Remedy
High temp.!
Lamp off in 1 min.
Internal temperature is too high. Turn off the power.
Check to see if nothing is blocking the ventilation
holes.
Check to see if the air filter is clogged with dust.
(Do not use an air filter for more than 500 hours.)
Frequency is out of range!
This input signal cannot be projected as
the frequency is out of the acceptable
range of the projector.
Input a signal that is within the frequency range.
The resolution setting of the output
signal of the computer is too high.
Set the setting of output to XGA
(see page
17 (GB)).
Please check INPUT-A
setting.
You have input an RGB signal from the
computer when INPUT-A in the SET
SETTING menu is set to COMPONENT,
DTV YP
BPR or DTV GBR.
Set INPUT-A correctly
(see page 30 (GB))
.
Please check INPUT-B
setting.
You have input an RGB signal from the
computer when INPUT-B in the SET
SETTING menu is set to COMPONENT,
DTV YP
BPR or DTV GBR.
Set INPUT-B correctly
(see page 30 (GB))
.
The electrical system has failed.
Please replace the LAMP.
Replace the lamp.
Both LAMP/COVER and
TEMP/FAN indicators light up.
Wait for 120 seconds to cool down the lamp and
turn on the power again
(see page 22 (GB))
.
Consult with qualified Sony personnel.
Please replace the filter. The air filter is clogged with dust. Replace the air filter.
It is time to replace the lamp.
Remote Commander
Symptom
Cause
Remedy
The Remote Commander
does not work.
The Remote Commander batteries are
dead.
The remote control cable is not
connected to the CONTROL S IN
connector (projector) or CONTROL S
OUT (Remote Commander).
Replace with new batteries
(see page 15 (GB))
.
Connect the remote control cable to both the
projector and Remote Commander, or disconnect
the cable
(see page 15 (GB))
.
The front/rear remote control detector is
near a fluorescent lamp.
Change the setting of SIRCS RECEIVER in the
SET SETTING menu
(see page 30 (GB))
.
There are no batteries in the Remote
Commander.
Install batteries
(see page 15 (GB))
.
44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sony VPLVW12HT wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Sony VPLVW12HT

Sony VPLVW12HT Bedienungsanleitung - Englisch - 148 seiten

Sony VPLVW12HT Bedienungsanleitung - Spanisch - 148 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info