GB - 7
AUX IN OPERATION
Caution: Turn off power and unplug the power cord before connection.
Connect to other audio equipment, including video recorder to provide sound output
for other audio equipment.
Preparation
1. Connect these audio equipments "LINE OUTPUT" to "AUX IN" socket
of the unit through an audio cable (not included).
2. Press the AUX IN / ON button once to turn on power and into AUX
IN mode.
3. The AUX indicator will light up on the LCD.
4. Press VOLUME +/- button to increase or decrease sound level.
5. To turn the unit off after use, simply press the STOP/OFF button
once.
RADIO OPERATION
1. Press RADIO/BAND button once to turn on radio power, RADIO
will light up on the LCD.
2. Press RADIO/BAND button again to select radio band.
3. Press the TUNE/TIME button + or – momentarily (less than 0.5 sec.) to step up or down
the receiving frequency in order to select the desired station.
4. For auto tuning, keep pressing the TUNE/TIME button + or – (more than 0.5 sec.) until
the displayed frequency starts to change, then release the button. Tuning will stop
automatically when a station is received.
5. Adjust the sound level by pressing VOLUME +/– buttons.
6. To turn the unit off after use, simply press STOP/OFF button once.
NOTE: After radio frequency is displayed for about 10 seconds, the LCD will show the current
time. Pressing the RADIO/BAND button once will show radio frequency again.
Improving the reception
• Extend the FM wire antenna which is located on the back of unit, and change its position
until the best FM reception is found.
• The unit has a built-in ferrite bar antenna for MW radio reception. Check the condition of
MW reception before xing this unit in position.
• Install the unit as far as possible from a source of noise. (for example : refrigerator,
microwave oven, uorescent lamp, etc.)
PRESET STATIONS
1. Press the RADIO/BAND button to the desired band.
2. When the desired station is tuned, press MODE / PROGRAM
button to enter saving mode.
3. The preset location will ash on the LCD, press PRESET/ALBUM / button to select
preset channel.
4. Press MODE / PROGRAM button again to save into memory. If it has previously set, the
former station is replaced.
5. Repeat step 1 ~ 4 to store more preset stations.
NOTE: The preset memory can store a maximum of 12 stations for FM band and 12 stations
for AM band.
RECALL A PRESET STATION
To recall any preset stations within the selected band, simply press the PRESET/ALBUM
/ buttons until the preset radio frequency appears on the display.
