Bedienungsanleitung Soundmaster URD-750 (Seite 4 von 11) (Englisch)

673313

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

Power Source

This system is designed to operate on 230VAC 50Hz house current only. Connecting this

system to any other power source may cause damage to the system and such damage is not

covered by your warranty.

Note: The system has polarized AC plug with one wide blade and one narrow blade. The plug

will only fit into matching polarized AC outlets.

Battery Back Up System

This unit uses a single 9-Volt battery (not included) to maintain the time and alarm settings in

event that it is accidentally unplugged, or you experience a temporary power failure. We

recommend that you install a well-known brand of Alkaline battery for longest life and best

performance. To keep the battery back up system operational you should install a new battery

every 6 to 9 months. Some people find it convenient to replace the back up batteries in their

alarm clocks, clock radios, and smoke detectors too, at the beginning and end of Daylight

Saving Time.

OPERATING INSTRUCTIONS

Setting The Correct Time And Day

NOTE: Connect the power cord to your AC outlet. Make sure to use an outlet that is always ‘live’.

Do not use an outlet that is controlled by a wall switch.

1. When the unit is plugged in for the first time, the clock display will begin flashing “0:00”

(AM).

2. Press and hold the CLK-ADJ/PROG. button for at least two seconds until only the Hour digits

continue to flash.

3. While the Hour digits are flashing press the TIME-DN/F.REW or TIME-UP/F.FWD buttons

repeatedly to set the clock to the correct Hour.

4. When the correct hour is flashing, press the CLK-ADJ/PROG. button again. The Minute

digits begin flashing.

5. While the Minute digits are flashing press the TIME-DN/F.REW or TIME-UP/F.FWD buttons

repeatedly to set the clock to the correct Minutes.

6. Press the CLK-ADJ/PROG. button. The Day indicator “ d:1 ” begins to flash.

7. While the day indicator is flashing, press the TIME-DN/F.REW or TIME-UP/F.FWD buttons

repeatedly to set the display to the correct ‘Day’. (1 = Monday, 2 = Tuesday, etc.)

8. When the correct ‘day’ (digit) appears on the display press the CLK-ADJ/PROG. button once

more to exit the clock-setting mode. The display stops flashing and returns to the correct time

and the clock begin to run.

IMPORTANT: After you press the CLK-ADJ/PROG. button you must make your time

adjustments within 10 seconds while the display is flashing. After 10 seconds the display stops

flashing and no time adjustments can be made. If this occurs you must begin with Step 2

above and start the time adjustment process again.

Listening To The Radio

1. Press the ALARM OFF/POWER button on the top panel to turn the unit ‘On’. The POWER

LED indicator comes on.

2. Press the RADIO/BAND button to select the Radio function. Either the AM/PROG. or the FM

indicator will come on to confirm which band is selected. Press the RADIO/BAND button

again to repeatedly switch between the AM and FM bands.

3. Rotate the TUNING control on the right side panel to tune to the desired station.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Soundmaster URD-750 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info