HOW TO INSTALL YOUR BATTERIES
HOW TO CHARGE YOUR HAVOC STINGER
®
HELICOPTER
HOW TO FLY YOUR HAVOC STINGER
®
HELICOPTER
1. SET THE BAND ON YOUR CONTROLLER:
2. TRIMMING YOUR HELICOPTER:
To do this, you must check which frequency letter your helicopter is set at.
Turn over the helicopter and you will find a letter (A,B,C) on the bottom.
Set the band selector on your controller to the same letter (A,B,C) by moving the horizontal switch found below the ON/OFF power switch.
1. The Havoc Stinger
®
will have around 5-6 minutes of flight time after a 20-30 minute charge.
2. Before you recharge the battery, wait 10-15 minutes to let the battery cool down.
Things to remember:
Gently push the throttle up to raise your helicopter .5 m (1.5 ft) to 1 m (3 ft) high off the ground.
If your helicopter turns CLOCKWISE, continue to push the LEFT side of the trim button REPEATEDLY until the turning stops
and the helicopter flies straight.
If your helicopter turns COUNTERCLOCKWISE, continue to push the RIGHT side of the trim button REPEATEDLY until the turning
stops and the helicopter flies straight.
Pull out the cover and take out
the charging wire.
Turn the helicopter OFF
using the OFF/ON switch on
the underside.
Insert the charge plug into
the socket on the side of the
helicopter.
When ON/OFF switch is set to ON,
the green LED will
light up when
charging. Once
completed it will
turn OFF. Pull
the plug out
from the
side of the
helicopter.
STEP ONE STEP TWO STEP THREE STEP FOUR
Keep turning clockwise
or
Spiral clockwise
Keep turning counterclockwise
or
STEP
ONE
STEP
TWO
STEP
THREE
Spiral counterclockwise
2
BATTERY INSTALLATION – CONTROLLER/CHARGER
1. Open the battery door with a screwdriver (pic.1). 2. If used batteries are present, remove these batteries from the unit by pulling up on one end of each
battery. 3. Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment (pic.2). 4. Replace battery door securely (pic.3).
5. Check your local laws and regulations for correct recycling and/or battery disposal.
pic.1 pic.3pic.2
3. FLYING INDOORS
NOTE: Your Havoc
Stinger
®
loses its trim
EVERY time you turn it
off. So remember these
helpful tips to stabilize
it every time!
Location – Fly in a wide-open room [ideally over 3 m (10 ft) (W) x 5 m (16.5 ft) (L) x 2.5 m (8 ft) (H)], away from breakable items. Avoid flying near vents and/or
fans, as these may overpower the Havoc Stinger
®
and make it difficult to control. NOTE: Always get permission to fly your Havoc Stinger
®
indoors.
CAUTION: Never fly near your face. Keep rotor away from your fingers, hair, eyes and other body parts. Always lift off from a flat surface.
Never hold the flying heli in your hand when lifting off. DO NOT launch heli near people or animals. Stay away from obstacles and electrical hazards.
OFF
ON
OFF
ON
OFF
ON
