Bedienungsanleitung Spirit ET288 (Seite 18 von 20) (Englisch)

584038

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

ET288/ET388

BELT / DECK LUBRICATION:

Do not lubricate with other than Spirit approved lubricant. Your treadmill comes with one tube of

lubricant and extra tubes can be ordered directly from Spirit. There are commercially available lube

kits, but the only one currently approved by Spirit is Lube-N-Walk. These kits come with an

application wand that makes applying the lubrication easier. The kits can be purchased from Spirit

or directly from Lube-N-Walk here: http://www.jadfitness.com/

When ordering make sure to specify

silicone lubricating kit, not paraffin wax.

Keeping the deck lubricated at the recommended intervals ensures the longest life possible for your

treadmill. If the lubricant dries out, the friction between the belt and deck rises and places undue

stress on the drive motor, drive belt and electronic motor control board, which could result in

catastrophic failure of these expensive components. Failure to lubricate the deck at regular

intervals may void the warranty.

The deck comes pre-lubricated and subsequent lubrication should be performed every 180 hours of

use. The console has a built in lubrication reminder indicator that lights every 180 hours of use. To

lubricate the deck with the tube of lubricant supplied it will be necessary to loosen the walking belt.

Using the 6 mm allen wrench supplied, loosen the two rear roller adjustment bolts -- located in the

rear end caps  enough to get your hand under the belt (5 10 turns). Make sure to loosen both

bolts the same amount of turns and also remember how many turns, because when finished you

will need to tighten the bolts back to the point they were before.

Once the belt is loose, wipe the deck with a clean lint free cloth to remove any dirt. Apply the whole

tube of lubricant onto the deck surface about 18 inches from the motor cover. Squeeze out the

contents of the tube across the deck (parallel to the motor cover) in about a one-foot long line, like

toothpaste on a toothbrush. The one-foot line should be in the middle of the deck at approximately

equal distance from both side edges of the belt. You want the lubricant to be applied about the spot

that your feet would hit the belt as you are walking. This should be about 18 inches from the motor

cover, but you may want to walk on the treadmill before loosening the belt to note where your feet

land on the belt. If you mostly run on the treadmill, the spot where your feet land may be different

from walking.

Once the lubricant is applied, tighten the rear roller bolts the same amount of turns as when you

loosened them. Run the treadmill at about 6 mph without walking on it for about a minute or two to

make sure the belt stays in the middle of the deck. If the belt tracks to one side then follow the belt

tracking instructions to remedy. Now the deck is lubricated and you should walk, not run, on the

treadmill immediately for at least 5 minutes to ensure the lubricant is evenly distributed. If you

purchase a Lube-N-Walk kit, follow the instructions that come with it to apply the lubrication.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Spirit ET288 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info