Bedienungsanleitung Spirit XT285 2011-2012 (Seite 5 von 17) (Englisch)

583924

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

Treadmill

XT285

Treadmill

XT285

Please read before unpacking your folding treadmill. Serious injury could occur if this folding treadmill

is not unpacked properly.

There is a Velcro strap installed around the treadmill base that prevents the treadmill from unfolding accidentally

during shipping. If this strap is not removed properly the treadmill could spring open unexpectedly and cause injury if

someone is standing near the treadmill when the strap is removed.

To ensure your personal safety during removal of the shipping strap please make sure the treadmill is positioned at

on the ground, in the orientation it would be in if you were using the treadmill. Do not turn the treadmill up on its

side while removing the shipping strap. This could cause the treadmill’s folding mechanism to spring open. If the end

of the Velcro strap (that you need to grab to remove it) happens to be under the treadmill deck, reach under the

deck to grab it, but do not tilt the treadmill up to gain access to the strap end.

Cut the banding straps with a short box cutter (razor knife); separate the carton from the one underneath it by

prying up on the staples (if applicable). Pull the carton over the treadmill parts and locate the hardware pack. The

hardware pack is separated into ve sections; one section containing tools and four sections labeled steps 1-4 which

contain the hardware needed for assembly of each step. The assembly steps below are numbered one through four

and correspond to the hardware in the numbered sections of the hardware pack. Remove only the hardware for the

step you are currently assembling to avoid confusion and mix ups.

Then remove the treadmill from the carton and lay it on a level surface.

Important Operation Instructions

Pre-Assembly

XT285

Assembly Instructions

Assembly Tools

 NEVER operate this treadmill without reading and completely understanding the results of

any operational change you request from the computer.

 Understand that changes in speed and incline do not occur immediately. Set your desired

work level on the computer console and release the adjustment key. The computer will obey

the command gradually.

 NEVER use your treadmill during an electrical storm. Surges may occur in your household

power supply that could damage treadmill components. Unplug the treadmill during an

electrical storm as a precaution.

 Use caution while participating in other activities while walking on your treadmill; such as

watching television, reading, etc. These distractions may cause you to lose balance which may

result in serious injury.

 Do not use excessive pressure on console control keys. They are precision set to function

properly with little nger pressure.

 A safety tether cord is provided with this unit. It is a simple magnetic design that should be

used at all times. It is for your safety should you fall or move too far back on the tread-belt.

Pulling this safety tether cord will stop tread-belt

movement. To Use:

1. Place the magnet into position on the round metal portion of the console control head.

Your treadmill will not start and operate without this. Removing the magnet also secures

the treadmill from unauthorized use.

2. Fasten the plastic clip onto your clothing securely to assure good holding power. Note: The

magnet has strong enough power to minimize accidental, unexpected stopping. The clip

should be attached securely to make certain it does not come off. Be familiar with its

function and limitations. The treadmill will stop, depending on speed, with a one to two

step coast anytime the magnet is pulled off the console. Use the Stop / Pause switch in

normal operation.

Safety Tether Cord

#96. Combination M5 Allen Wrench/

Phillips Head Screw Driver

#97. M6 Allen

Wrench

#33. Safety Key

#58. Deck/Belt

Lubricant

#122. Phillips Head Screw Driver

To assist you in assembling your new Spirit Fitness treadmill, we have posted an assembly video at the following link:

http://www.spirittness.com/customerservice/video/treadmillvideos.html

Assembly Video

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Spirit XT285 2011-2012 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info