644336
3
Zoom out
Zoom in
Vorherige Seite
1/8
Nächste Seite
2
3
CONTROL PANEL
1. MIC This is an XLR type connector for microphones.
The input level ranges from -60 to -20dB. This connector can
provide +48V phantom power for condenser microphones
when the phantom power is switched on.
2. LINE This is a balanced 1/4” phone jack for linking a line
level source The input level ranges from -40 to 0dB.
3. GAIN Use this knob to adjust the level of the input signal
to the optimal level. For optimal S/N ratio and dynamic
range, adjust this knob so that the peak indicator lights up
occasionally.
4. LOW CUT Push down this switch to activate a low cut  lter,
which allows high frequencies but attenuates low frequencies.
5. HI This control determines the level of high frequencies in
the output signal.
6. MID This control determines the level of mid frequencies
in the output signal.
7. LOW This control determines the level of low frequencies
in the output signal.
8. AUX (4M4S ONLY) Use this knob to control the signal
level sent from each channel to the AUX bus. It is set before the
channel fader, so it is not dependent on the fader position.
8. EFF (4M4S D ONLY)
Use this knob to control the signal level sent from each channel
to the built-in effects processor. It is set after the channel fader,
so it is dependent on the fader position. Adjust this knob when
you use effects processor on this channel.
9. PAN This control is used for distributing the signal level
of the channel feed to L / R buses. When the control is set to
12 o’clock, the signal is split evenly between L and R.
10. PEAK Indicator This LED signal will warn you of any
excessively high signal levels in the channel. The signal is
sampled in front of channel fader. It will light approximately
3dB before clipping and therefore give warning of a possible
overload.
11. LEVEL (Channel Fader)
This rotary fader controls the output level feed to the main bus
from the input channel, adjusting the volume balance between
the channels.
MONO CHANNEL SECTION
3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Stagg S MIX 4M4S wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Stagg S MIX 4M4S

Stagg S MIX 4M4S Bedienungsanleitung - Deutsch - 8 seiten

Stagg S MIX 4M4S Bedienungsanleitung - Französisch - 8 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info