Bedienungsanleitung Stanley SFMCHTB866 (Seite 12 von 124) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

720491

Zoom out

Zoom in

Vorherige Seite

1/124

Nächste Seite

ENGLISH

NOTE: The fuel gauge is only an indication of the charge left on

the battery pack. It does not indicate tool functionality and is

subject to variation based on product components, temperature

and end-userapplication.

OPERATION

Instructions for Use



WARNING: Always observe the safety instructions and

applicableregulations.



WARNING: To reduce the risk of serious personal

injury, turn tool off and disconnect battery pack

before making any adjustments or removing/

installing attachments or accessories. An accidental

start-up can causeinjury.

Proper Hand Position (Fig.C)



WARNING: To reduce the risk of serious personal injury,

ALWAYS use proper hand position asshown.



WARNING: To reduce the risk of serious personal

injury, ALWAYS hold securely in anticipation of a

suddenreaction.

Proper hand position requires one hand on the switch

handle

3

and one hand on the bail handle

5

. Never hold the

unit by the blade guard

4

Switch (Fig.D)



WARNING: Never attempt to lock a switch in

the ONposition.



CAUTION: Do not cut stems greater than

3/4" (19mm). Use the trimmer only for cutting normal

shrubbery around houses and buildings. NOTE:Powersaw

can cut stems and branches up to 1.5" (38.1 mm).

To turn the unit on, push the lock-off switch

2

forward as

shown in FigureB, and squeeze the trigger switch

1

. Once the

unit is running, you may release the lock offswitch.

In order to keep the unit running you must continue to squeeze

the trigger. To turn the unit off, fully release the trigger and allow

the lock-off switch

2

toengage.

Trimming Instructions

Working Position (Fig.E)

Maintain proper footing and balance and do not overreach.

Wear safety goggles, non-skid footwear when trimming. Hold

the unit firmly in both hands and turn the unit on. Always hold

the trimmer as shown in Figure G, with one hand on the switch

handle

3

and one hand on the bail handle

5

. Never hold the

unit by the blade guard

4

Trimming New Growth (Fig.F)

Using a wide, sweeping motion, feeding the blade teeth

through the twigs, is most effective. A slight downward tilt of

the blade in the direction of motion gives the bestcutting.

Level Hedges (Fig.G)

To obtain exceptionally level hedges a piece of string can be

stretched along the length of the hedge as aguide.

Side Trimming Hedges (Fig.H)

Orient the trimmer as shown and begin at the bottom and

sweepup.



DANGER: KEEP HANDS AWAY FROMBLADES.



WARNING: To guard against injury, observe the following:

• READ INSTRUCTION MANUAL BEFORE USING. SAVE

INSTRUCTIONMANUAL.

• Check the hedge for foreign objects such as wires or

fences before eachuse.

• KEEP HANDS ON HANDLES. DON’TOVERREACH.

• DO NOT USE UNDER WETCONDITIONS.



CAUTION: BLADE MAY COAST AFTER TURNOFF.

MAINTENANCE

Your STANLEYFATMAX power tool has been designed

to operate over a long period of time with a minimum of

maintenance. Continuous satisfactory operation depends upon

proper tool care and regularcleaning.



WARNING: To reduce the risk of serious personal

injury, turn tool off and disconnect battery pack

before making any adjustments or removing/

installing attachments or accessories. An accidental

start-up can causeinjury.

The charger and battery pack are notserviceable.

Lubrication

1. After use, carefully clean the blades with a resinsolvent.

2. After cleaning, apply a light film of lubrication to the

exposedblade.

3. Turn the trimmer vertical with the blades toward the ground

and run the trimmer for a few seconds to fully disperse

thelubrication.

4. Slide the sheath

7

over the blade as shown in figureK.

Blade Maintenance (Fig.I)

The cutting blades are made from high quality, hardened steel

and with normal usage, they will not require resharpening.

However, if you accidentally hit a wire fence (Fig.J), stones, glass,

or other hard objects, you may put a nick in the blade. There

is no need to remove this nick as long as it does not interfere

with the movement of the blade. If it does interfere, remove

the battery and use a fine toothed file or sharpening stone to

remove the nick. If you drop the trimmer, carefully inspect it for

damage. If the blade is bent, housing cracked, handles broken

or if you see any other condition that may affect the trimmer’s

operation contact your local authorized service center for repairs

before putting it back intouse.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stanley SFMCHTB866 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info