Bedienungsanleitung Stiga Dino 45 (Seite 4 von 9) (Englisch)

608689

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

ENGLISH

SYMBOLS

The following symbols are displayed on the

machine in order to remind you about the safety

precautions and attention necessary when using

the machine.

The symbols mean:

Warning! Read the Instruction Book and

Safety Manual before using the machine.

Warning! Keep spectators away. Beware

of objects being flung out.

Warning! Do not put hands or feet under

the cover of the machine when it is

running.

Warning! Before starting any repair work,

remove the spark plug cable from the

spark plugs.

Warning! Always tilt the

lawnmower backwards when

cleaning the underside. Petrol and

oil can run out if the lawnmower is

tilted in the other direction.

ASSEMBLING

EJECTION SHIELD

Under no condition must the machine be

started without the ejection shield being

fitted on the machine. If it is not fitted,

stones and other flying objects may easily

be ejected by the rotating blade.

The parts for assembly of the ejector shield are

attached to the packaging. Remove the parts and

assemble the ejector shield according to fig. l.

Tighten the screws securely.

HANDLEBAR

Hinge up the lower part of the handlebar.

The components for assembling the upper section

of the steering are fitted for packing purposes.

Remove the components from the lower section of

the steering.

Then attach the upper part of the handlebar with

screws, washers and locking knobs (fig. 2).

The handlebar has four different positions. Release

the catch with the foot and move the handlebar to

the desired position (fig. 3).

1. For normal mowing.

2. For mowing under trees, shrubs etc.

3. Parking position.

4. Transportation and storage position. The

handlebar takes up less room if the locking

knobs are loosened and the handlebar folded in.

CABLE HOLDER

Put the wires into the cable holder (fig. 4).

EYELET FOR STARTER HANDLE

Attach the starter handle to the eyelet on the

steering handle (fig. 5).

USING THE MOWER

BEFORE STARTING

FILL THE CRANKCASE WITH OIL

The lawn mower is delivered without any

oil in the engine crankcase. The

crankcase must, therefore, be filled with

oil before the engine is started the first

time.

Remove the oil dipstick (fig. 6).

Fill the engine's crankcase with 0.6 litres of good

quality oil (service class SE, SF or SG) Use SAE

30 or SAE 10W-30 oil.

Fill until the oil reaches the “FULL/MAX” mark

on the dip stick. Do not fill with too much oil.

CHECKING THE OIL LEVEL

Check before using the machine that the oil level is

between “FULL/MAX” and “ADD/MIN” on the

dipstick. Stand the lawn mower on a level surface.

Remove and dry the dipstick (fig. 6). Slide it down

completely and tighten it. Unscrew and pull it up

again. Read-off. If the oil level is low, fill with oil

up to the “FULL/MAX” mark.

FILL UP THE PETROL TANK

Fill with petrol before starting the motor.

Never remove the filler cap or fill with

petrol while the motor is running or still

warm.

Never completely fill the fuel tank. Allow a little

room for the petrol to expand if necessary.

Some engines have an extra safety cover under the

regular fuel cap. This must not be reinstalled.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stiga Dino 45 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info