Edition Chapter Refers to model Page Chapter
Workshop Manual Stiga Park
9.5 Replacement of pul-
There are three different types of pulleys on
the unit. Firstly the pulleys on the interme-
diate shaft A. These are journalled with two
ball bearings. To remove these pulleys from
the shaft the attachment plate’s four screws
must be removed, since the shaft is secu-
red with a nut on the underside of the plate.
The two return pulleys B and C are journal-
led with one ball bearing each. These shaft
are also secured with a nut from the un-
The large pulleys D and E are mounted di-
rectly on the blade shafts.
To avoid breakdowns it is impor-
tant that the nut on the blade shaft is
tightened to the correct torque.
The nut must always be tightened to a
torque of 40Nm.
Do not overtighten the nut since this will
damage the thread
Dismantling of pulley on blade
Dismantling of deck belt, see section 9.4.
The blades are sharp. Always
wear gloves when working with the bla-
des to avoid injury.
1. Release the nut on the blade shaft and
remove the pulley.
Replacement of belt