PART 1 • English
19
English
Symptom Cause Solution
Message “No or Bad signal” Wrong satellite selected in the menu
Wrong parameters set in the menu
Wrong alignment of the dish or
problem with coax cable
Press the SETUP button on the RCU and select the
correct satellite in the menu “Antenna Setup”.
Check settings in LNB- and Channel set up menu
Ask your dealer to check the outdoor unit and antenna
coaxial cable or F-connector to LNB
Remote control is not working The batteries of the remote control
are not inserted or exhausted
Check whether the batteries are inserted correctly in
your remote control. Check the batteries, and if they are
exhausted, replace them
A.2 SPECIFICATIONS
Tuner
Input Frequency Range: 950 ~ 2150 MHz
Input signal level: -65 ~ -25dBm
LNB Power: 13/18 V DC, max. 400 mA
LNB switch control: 22 kHz
DiSEqC Version 1.0 & 1.2 compatible, USALS
Demodulator
Modulation: QPSK
Input Symbol Rate: 2 ~ 45 Ms/s
SCPC & MCPC signals from C & KU band satellites
Video Decoder
Profile level: MPEG-2 Main profile @ Main level
Data Rate: Up to 15 Mbit/s
Video Resolution: 720 x 576, 720 x 480
Video Format: NTSC, PAL, SECAM
Aspect Ratio: 4:3, 16:9
Audio Decoder
MPEG-1/MusiCam Layer I & II;
Audio mode: Mono, Dual mono, Stereo
Sampling Rate: 32, 44.1, 48 kHz
Connectors
SAT IN
SAT OUT
1 TV SCART (RGB,CVBS, Y/C, Audio)
1 VCR SCART (CVBS, Y/C, Audio)
2 RCA (Audio L & R)
Coaxial Digital Audio: S/PDIF
Power switch
System & Memory
Main Processor: STi5518
Flash Memory: 2 MBytes
SDRAM: 8 MBytes
