568532
21
Zoom out
Zoom in
Vorherige Seite
1/23
Nächste Seite
18
PART 1 • English
7.4.5 Factory Reset
A factory reset will restore your receiver to the factory default settings. To reset the receiver, you have to enter
your PIN code (Default PIN:0000). After the reset, the receiver will start up in the Setup Wizard.
WARNING: A factory reset will permanently delete all your personal settings, timers and stored
channels. Please consider this before you perform a factory reset.
7.5 Games
Your receiver is equipped with 4 games.
To play a game, select one of the four available games (Sudoku, Tetris, Snake or Box) and press OK to
enter the game. Please follow the directions on screen.
8.0 TROUBLESHOOTING
There may be various reasons for abnormal operation of the receiver. Please check the receiver according
to the procedures shown below. If the receiver does not work properly after checking it, please contact
your local Serviceline or STRONG dealer. Alternatively you can send a support mail via our website: www.
strong.tv. NEVER open or disassemble your receiver. This may cause a dangerous situation and will void
the warranty.
Symptom Cause Remedy
The display on front
panel does not light
up.
The power cord is not plugged in. Check that the power cord is plugged
in to the wall outlet. Make sure power
switch on rear panel is in ON position.
Receiver switched to STBY and the
display function is switched OFF.
Check if receiver is in STBY and the
setting within the menu Setup>Time
Setting>Time Display is set to OFF
No picture or sound Wrong connection or setting of the
Audio/Video output of the receiver
to TV.
Connect the Audio/Video output of
the receiver to TV correctly and check
the adjusted settings in the menu
Setup> Output Options.
Audio muting. Press the MUTE button.
TV power off. Turn TV on.
No picture The receiver can’t receive the signal. Check the antenna cable, replace the
cable, or connect the cable to the
receiver tightly.
Incorrect values of some tuner
parameters.
Set the values of tuner parameters
correctly in menu Installation>
Satellite Settings.
Wrong direction of the dish. Check the signal strength with a
spectrum analyzer and adjust your
dish correctly.
The remote control
does not work
The batteries of the remote control
are not inserted, wrongly inserted or
exhausted.
Check whether the batteries are inserted
correctly or exhausted, if so replace the
batteries in the remote control.
21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Strong SRT 7300 CI plus wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Strong SRT 7300 CI plus

Strong SRT 7300 CI plus Bedienungsanleitung - Deutsch - 29 seiten

Strong SRT 7300 CI plus Bedienungsanleitung - Englisch - 23 seiten

Strong SRT 7300 CI plus Bedienungsanleitung - Holländisch - 23 seiten

Strong SRT 7300 CI plus Bedienungsanleitung - Französisch - 23 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info