517161
24
Zoom out
Zoom in
Vorherige Seite
1/31
Nächste Seite
24
§CHECKING AND CHANGING FUSES §
Turn off ignition switch, and check fuses if they are intact. Replace the blown fuse with a new one having
the same specified amperage rating (15A). Using a fuse of more than 15 amperes, a brass or iron wire
to replace a blown fuse is strictly prohibited to avoid damaging the electrical system and the circuit.
Remove the left side cover, and you’ll find the fuse holder near battery.
Open the fuse holder, and pull out the fuse. Check it for damage or broken.
Fuses must be firmly secured with wire connectors when replacing. Loose connections will result
in overhead and damage.
Use only parts having the specified specification to replace electrical components such as light
bulbs. Using parts not having the specified specifications for replacement may cause the fuse to
blow and over-discharge the battery.
Avoid spraying water directly on or around fuse box when washing the motorcycle.
If the new fuse burn out quickly again, please check the faulty reason before replace it again.
Take your motorcycle to your dealer for an inspection if a fuse is blown by unknown causes.
Fuse
CAUTION:
In order to prevent electric leakage and self-discharge when the battery sits idle for long
periods. Remove battery from motorcycle, store it in a well- ventilated and dimly lighted place
after the battery has been fully charged. Disconnect battery’s negative cable if the battery is
still kept on the motorcycle.
If the battery needs to be replaced, replace with a same type battery.
The electrolyte level is incorrect if the motorcycle is not standee on level ground.
Don’t over fill the distilled water other wise the over flay acid fluid will corrode parts.
Keep away from sparks and flames when dealing with the battery.
Don’t clog the breather tube.
The breather tube clogged will break the battery because the inner pressure will be up.
Keep your eyes and skin away from the electrolyte, if touched by the electrolyte, clean with
water immediately or see the doctor.
Notice the polarity of the cables when removing and assembling.
Wire
REMOVE
INSTALLATION
Wire
Fuse joints
24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sym WOLF 125 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info