726519
3
Zoom out
Zoom in
Vorherige Seite
1/58
Nächste Seite
TROLLING MOTOR USER MANUAL
3
WIRING AND BATTERY RECOMMENDATION
Battery Type
Recommended battery(s): 12-volt Deep Cycle battery or Marine battery, battery should has at least 55 ampere hour
rating or higher. To extend running time an additional battery can be used. See section on battery connection
method.
Cable Size
If extending the standard battery cable supplied with the product, recommends the use of 13m wire (6-gauge
wire, AWG).
Warning: Be sure all switches are in the OFF position before connecting to battery or batteries.
Electrical arcing near the battery could ignite hydrogen gas and cause the battery to explode.
SAFETY INFORMATION
Do not allow children under 16 to operate the electric outboard motor.
Do not modify the unit in any way or add accessories not intended for this product.
Never fully submerse the unit, if unit is accidentally submersed disconnect battery and leave to dry.
Warning: Always disconnect power from the motor when replacing propeller, removing debris
around the prop, charging batteries, transporting boat or when the motor is not in use.
FIRST TIME RUNNING
BATTERY CONNECTION METHOD
Before connecting the motors cables to the battery, ensure switch is in the OFF position and stand clear of the
propeller. Connect the red cable to the positive (+) terminal and the black cable to the negative (-) terminal, making
sure the terminals are clean before doing so. A clean connection will minimize power wastage and give you
maximum power from the battery. (A). The battery should be kept in a well-ventilated location. We recommend
using a special deep cycle marine battery for optimum performance.
(A) (B)
ATTACHING THE MOTOR TO YOUR BOAT
Attach the motor to the stern of the boat and tighten both mounting bolts securely while taking care not to
over-tighten. To adjust the angle of the motor after attachment, hold the motor head with one hand and depress
the positioning pin at the top of the mounting bracket with your other hand. Press and hold the positioning pin until
the desired angle has been reached, next release the pin and ensure the mechanism locks securely. (B)
Warning: Before the installation, make sure the area between the boat wall and the motor bracket is
clear.
3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Talamex TM66 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Talamex TM66

Talamex TM66 Bedienungsanleitung - Holländisch - 8 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info