When connecting, either disconnect the power plug from
the power outlet or turn off the unit’s power using the
POWER switch (if any).
Check the left and right channels and connect properly
(Left to L and Right to R).
Insert the plugs securely. Improper connection can lead to
generation of noise.
E.g. compact disc player
Connect the CD terminals to the OUTPUT terminals on the
compact disc player using the pin-plug cord.
Connect the REC OUT terminals to
the input (LINE IN) terminals on the tape deck using the
(I N) REC PLAY( OUT)
SUB OUT terminals
These terminals are used to connect to an active subwoofer.
Use pin-plug cords to connect the terminals to the INPUT
terminals on the subwoofer.
To avoid damaging the speakers with a sudden high-level
signal, be sure to switch the power off before connecting the
Check the impedance of your speakers.
Connect speaker with an impedance of 4 ohms or more.
The amplifier’s red speaker terminals are the + (positive)
terminals and the black terminals are the – (negative)
The + side of the speaker cable is marked to make it
distinguishable from the – side of the cable. Connect this
marked side to the red + terminals and the unmarked side
is the black terminal.
Prepare the speaker cords for connection by stripping off
approximately 10 mm or less (no more as this could cause
a short-circuit) of the outer insulation. Twist the wires
tightly together so that they are not straggly.
1. Unscrew the knob
2. Insert the speaker cable.
3. Tighten the knob and secure the cable.