541943
4
Zoom out
Zoom in
Vorherige Seite
1/6
Nächste Seite
P. 4
During reception, the signal strength may move from 1 bar to 2 bars to 3 bars. This is normal since
the clock is detecting DCF signal and other signals in the air at the same time.Press SET will return
to the time display with icon flashing.
Successful reception or failed reception
icon becomes static on (stop blinking) when reception is successful
icon disappears when reception is failed
Automatic reception and manual reception
Your clock starts automatic reception everyday at 1:00, 2:00, and 3:00. If it fails to receive the DCF
time signal at 3:00, it will start reception at 4:00. If it fails again, it will start reception at 5:00. If it
fails again, it will start automatic reception at 1:00 again in the next day.
For manual reception simply press and hold / WAVE, your clock will gives a short beep and
starts manual reception. Press and hold / WAVE to stop DCF reception.
During RCC reception, all buttons do not function and it does not take temperature and humidity
measurement. The temperature and relative humidity readings will get stable and become more
accurate after your weather station clock is powered up for around 30 minutes.
To cancel DCF reception permanently
Press and hold / WAVE and at the same time for 2 seconds, your clock will give 2 short
beeps and the radio controlled function is permanently disabled.
To resume the radio controlled function, press and hold / WAVE and at the same time for 2
seconds, your clock will give 2 short beeps and will start DCF immediately.
Note: Keep in mind that your outdoor transmitter has a 30-meter open air transmission with no
obstructions. Actual transmission range will vary depending on what is in the path of the signal.
Each obstruction (roof, walls, floors, ceilings, thick trees, etc.) will effectively cut signal range in half.
ZEITEINSTELLUNG
1. Press and hold SET for 2 seconds, hour digits flash. Press / to set hours.
2. Then press SET once again, the minute digits flash. Press / button to set minutes.
3. Then press SET once again, display shows :05 and flash. Press / button to set snooze
duration from 5 minutes to 60 minutes.
4. Press SET to return to normal mode or it will return to normal mode in around 8 seconds if no
further press of any other buttons.
5. Your clock is in 24-hour display format.
ALARMEINSTELLUNG
(default alarm setting is 6:00 AM)
1. Press and hold ALM, the hour digits flash with AL icon flashing. Press / to set your
desired alarm hours.
2. Press ALM once again, the minute digits flash. Press / to set your desired alarm
minutes.
3. Press ALM once to store your alarm setting and return to normal time display, or the clock
will return to normal mode in around 8 seconds if no further press of any other buttons.
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

techno-line-ws-6815

Suche zurücksetzen

  • Die Aussentemperatur Anzeige funktioniert nicht mehr . Batterien ausgewechselt, Reset an beiden Teilen durchgeführt und bereits den Aussensender ausgetauscht ! Leider kein Erfolg . An was kann es noch liegen ? Eingereicht am 17-4-2019 08:36

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Techno line WS 6815 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Techno line WS 6815

Techno line WS 6815 Bedienungsanleitung - Englisch - 6 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info