Bedienungsanleitung Technomax Trony GTR-4P (Seite 2 von 2) (Englisch)

622565

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

•

While green LED is still on, enter desired time-delay, whit 2 digit number ex. :

00 for no delay.

05 for 5 minutes time-delay.

20 for 20 minutes time-delay.

99 for 99 minutes time-delay.

If errors have been made while setting your new code, this will be indicated by the red “ERROR” LED

lighting up and a beep. Repeat the procedure for setting your new personal code again.

The code set before the incorrect procedure will remain in memory (for new safe “1111”).

•

Before finally closing the safe, it is advisable to check that everything is OK by operating

the opening and closing mechanism a number of times with the door open. Then shut the

door and turn the knob anticlockwise until it is closed

OPENING THE SAFE USING YOUR PERSONAL CODE

Enter your personal code set earlier and press “ENTER”. The green “OK” LED lights up for five

seconds. Within this time, turn the knob clockwise and open the door (if the time-delay is 00

minutes).

SIGNAL INDICATING THAT INTERNAL BATTERIES IS GOING FLAT

When the internal battery begins to go flat, this is indicated at the end of the opening procedure, by

the red “BATTERY” LED lighting up and a low beep tone. At this point, it will still be possible to open

the safe a number of times. Replace the internal batteries with 4 x LLR6 AA 1.5V alkaline batteries

EMERGENCY OPENING IN CASE OF BLACK-OUT AND/OR FLAT BATTERIES

In these cases , a new 9-volt LR61 alkaline battery will be necessary.

Press the 9-volt battery contacts firmly on the corresponding contacts on the keyboards, ensuring

that they are positioned correctly (the “-“ of the battery touching the bigger contact and the “+” of the

battery touching the small contact). With the battery firmly in position, key in code and open door.

Replace internal batteries immediately.

CAUTION

Replace the 4 x LLR6 AA 1.5 V alkaline batteries every year It must be remembered that even

new, packed batteries can sometimes be defective, for various reasons, or have a brief

duration. In the event of failure of the magnet release, or other faults, first of all, replace the

battery with a new 4 x LR6 AA 1.5 V alkaline batteries (DURACELL LR6 AA is recommended)

The manufacture declines all responsibility for failure to observe the instructions given, or for

improper use of the safe, thus causing the warranty to lapse.

Versions with EMERGENCY KEY

OPENING WITH EMERGENCY KEY

•

Remove the adhesive label marked with the letter “E” (see pic. 1).

•

Insert the key and open the lock up to the stop point.

•

Open the door.

•

Once the door is open, turn the knob anticlockwise until the bolts are fully extended.

•

Close the lock and remove the key.

WARNING!

NEVER LEAVE YOUR

EMERGENCY KEY IN THE SAFE

PIC.1

PIC. 3

VOLTAGE TRANSFORMER

JACK CONNECTOR

PROGRAMMING BUTTON

PIC. 2

Batteries case

TO BE REMOVED

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Technomax Trony GTR-4P Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Technomax Trony GTR-4P

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info