Bedienungsanleitung Telwin GEMINY 10 (Seite 3 von 56) (Alle Sprachen)

627084

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

5. OPERATION voltage over the battery terminals. When this

BEFORE CHARGING voltage reaches 14.4 / 28.8 Volt (this can be easily

NB: Before charging check that the capacity of detected by a normal tester) it is advisable to

the battery (Ah) which is to be charged, is not stop charging.

inferior to that reported on the data plate. (C ________________________________________

min).

Follow the instructions, taking great care to

END OF CHARGING

- Disconnect the power supply to the battery

respect the order given below.

charger by disconnecting the cable from the

- Remove the caps of the battery (if present) to

mains outlet.

allow release of the gases produced during

- Disconnect the black charge clamp from the

charging.

chassis of the vehicle or from the negative

- Check that the level of the electrolyte covers the

terminal of the battery (- symbol).

plates of the battery. If these are not covered add

- Disconnect the red charge clamp from the positive

distilled water and cover them up by 5-10 mm.

terminal of the battery (+ symbol).

________________________________________

- Store the battery charger in a dry place

- Close up the battery cells with the appropriate

WARNING: TAKE THE GREATEST CARE

caps (if present).

D U R I N G T H I S O P E R AT I O N A S T H E

ELECTROLYTE IS A HIGHLY CORROSIVE ACID.

________________________________________

The battery charger is equipped with safety cutouts

Please remember that the exact charge status of the

that trigger in the event of:

battery can only be determined by using a

- Overload (too much current delivered towards the

densimeter which allows measurement of the

battery).

specific gravity of the electrolyte; the following

- Short circuit (charging clamps set in contact with

indicate approximate density values for the solute

one another)

(Kg/l at 20°c):

- Inversion of polarity on battery terminals.

1.28 = charged battery

For battery chargers equipped with fuses, it is

1.21 = half-charged battery

necessary, in case of substitution of fuses, to use

1.14 = flat battery

spares having the same nominal current value as

- Check the battery voltage and make sure that the

the fuse changed.

settings on the battery charger panel are

________________________________________

compatible with the specifications for the battery

to be charged.

WARNING: If fuses with current values

- Check the polarities of the battery terminals:

different from those given are used this could

positive for the + symbol and negative for the -

cause damage to people or objects. For the

symbol.

same reason never, ever, substitute the fuse with

NOTE: if the symbols are indistinguishable

a copper (or other material) bridge.

remember that the positive terminal is the one not

connected to the vehicle chassis.

The substitution of the fuses is to be done when

- Connect the red charge clamp to the positive

the mains cable is DISCONNECTED from the

terminal of the battery ( + symbol).

mains.

- Connect the black charge clamp to the vehicle

________________________________________

chassis, at a safe distance from the battery and

the fuel pipe.

7. USEFUL ADVICE

NOTE: if the battery is not installed in the vehicle,

- Clean the positive and negative terminals of

connect the clamp directly to the negative

possible oxidation so as to ensure good contact

terminal of the battery (- symbol).

with the clamps.

- Never ever allow the two clamps to come into

CHARGING

contact when the battery charger is plugged into

- Power the battery charger by inserting the power

the mains.

supply cable in the mains outlet.

- If the battery charger is used with a battery which

_____________________________________________

is always connected to a vehicle, check the

instruction and/or maintenance manual of the

vehicle under the paragraph: “ELECTRIC

WARNING: SEALED BATTERIES.

SYSTEM” or “MAINTENANCE”. Before charging

If you need to charge this type of battery, be most

it is advisable to disconnect the positive cable

careful. Charge slowly and keep on checking the

which is part of the electrical system of the

BATTERY CHARGER PROTECTIONS

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Telwin GEMINY 10 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info