Bedienungsanleitung Tesco KS17065A - 2 burner gas bbq (Seite 5 von 20) (Englisch)

770551

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Installation

Selecting a Location

This barbecue is for outdoor use only and should be placed in a

well-ventilated area, and on a safe and even surface. Never place

your barbecue below ground level. Take care to ensure that the

barbecue must be used on an incombustible floor.

The sides of the barbecue should NEVER be closer than 1 metre

from any combustible surface, including trees and fences and make

sure that there are no heat sources near the barbecue (cigarettes,

open flames, spark etc.). Keep this barbecue away from any

flammable materials!

Precautions

Do not obstruct any ventilation openings in the barbecue body.

Position the gas bottle on level ground next to the barbecue and

safely away from any source of heat. Should you need to install or

change the gas bottle, confirm that the barbecue is switched off,

and that there are no sources of ignition (cigarettes, open flame,

sparks, etc.) near before proceeding.

Fixing a Regulator to the Gas Bottle

Confirm all barbecue control knobs are in the off position. Connect

the regulator to the gas bottle according to your regulator and

bottle dealer’s instructions.

Leak Testing

(Always perform a leak test in a well-ventilated area)

Confirm all control knobs are in the off position. Turn the gas on

/ open the gas control valve on the gas bottle or regulator. Check

for leaks by brushing a solution of ½ water and ½ liquid detergent

/ soap over all the gas system joints, including gas bottle valve

connections, hose connections, and regulator connections. NEVER

USE AN OPEN FLAME to test for leaks at any time. If bubbles form

over any of the joints there is a leak. Turn off the gas supply at the

gas bottle. Retighten all joints. Repeat test. If bubbles form again

do not use the barbecue and contact your local distributor for

assistance. Always wipe the mixed solution (½ water and ½ liquid

detergent / soap) from all joints and connections after leak testing.

2 Burner Gas BBQ

Assembly Instructions

tesco.com

Preparation before cooking

To prevent foods from sticking to the cooking surface, please use a

long handled brush to apply a light coat of cooking or vegetable

oil before each barbecuing session. (Note: When cooking for the

first time, paint colours may change slightly as a result. This is

normal and should be expected.) During use, the protective coating

may come off the cooking surface. This is normal an is not harmful.

Line the drip pan with aluminium foil. This will make cleanup easy.

Lighting the main burner

1. Open the barbecue hood.

2. Ensure all knobs are in the off position. Open the gas control

valve on the gas bottle or regulator.

3. Push in and turn the control knobs to the “Max” position. Press

the ignition button rapidly several times until left or right

portion of the the burner is lit. After succesful lighting of one

side, ignite the remaining portion of the burner. If the burner fails

to ignite after above procedures, turn all the knobs to the off

position. Close the gas valve on the gas bottle. Wait 5 minutes

and then repeat the above steps. If the barbecue still fails to light,

please refer to the manual ignition instruction in the section

below.

4. After ignition, the burner should be burned at the high

position for 3-5 minutes in order to preheat the barbecue.

This process should be done before every cooking session. The

hood (where applicable) should be open during preheating.

5. After completion of preheating, the burner should normally be

turned down to a lower position for best cooking results.

Manual Ignition Instruction for Main Burner

1. Insert lit match through the match-lighting hole at the side or

bottom of the barbecue body.

2. Push in and turn the control knob anti-clockwise to the max

position.

3. After the left or right portion of the burner is lit, light the

remaining portion of the burner.

4. If burner fails to ignite, contact your local dealer for assistance.

5. After ignition, the burner should be burned at the max position

for 3-5 minutes in order to preheat the barbecue. This process

should be done before every cooking session. The hood (where

applicable) should be open during preheating.

6. After completion of preheating, the burner should normally be

turned down to a lower position for best cooking results.

Operation

Warning:

• Before proceeding, make certain that you understand the

IMPORTANT INFORMATION section of this manual.

• Your barbecue is not designed to be used with more than 50%

of the cooking area as a solid plate —this includes baking

dishes. Full coverage will cause excessive build-up of heat and

damage the barbecue. This is not covered by warranty.

Produced in China for Tesco Stores Ltd.

©Tesco 2021.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tesco KS17065A - 2 burner gas bbq Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info