Bedienungsanleitung Teufel System 4 (Seite 14 von 16) (Englisch)

703864

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

· System 4

Subwoofer controls

level control to 10 o'clock. While the AV receiver

is outputting its white noise setup signal, slowly

turn up the subwoofer level to the desired vol-

ume.



Phase

This switch determines the phase relationship be-

tween the subwoofer and the front/centre speakers.

If the subwoofer is positioned in the speaker setup

as indicated on p. 9 (grey area of drawing), set the

phase to 0°. With other setups, the 180° setting may

produce better results.



Frequency

Use this control to set the crossover fre-

quency between the subwoofer's bass signal

and the bass frequencies of the other speak-

ers. If you are using an AV receiver, set the re-

ceiver's crossover frequency to 100 Hz and turn

the subwoofer's frequency control to maximum

(hard right).

➑

Power

OFF means that the subwoofer is switched off; ON

means that it is switched on.

➒

Power LED

When the subwoofer's mains power switch ➑ is

off, the power LED is off. When the subwoofer's

mains power switch ➑is on, the power LED lights

up red or green, depending on the position of the

Power Function switch .

When the subwoofer is permanently active

(= Power Function  ON), the power LED is green.

When the subwoofer is in standby mode (Power

Function  AUTO), the power LED is red. After

the subwoofer is triggered into activity, the LED

changes to green. After the subwoofer switches

itself off after 20 minutes of inactivity, the LED is

red again. When the Power Function switch  is

on OFF, the LED is red.

➓ Voltage selector

This switch adapts the internal amplifier to the

local mains voltage. NEVER set this to any other

value than the standard local voltage value. In

Germany, the correct position is “220 – 240V”.

{

Fuse

This is where the mains power fuse is located.



Power function

OFF means that the subwoofer is switched off; ON

means that it is switched on. AUTO means that the

subwoofer is operational but is only activated once

it receives an audio signal. In “AUTO” mode, the sub-

woofer automatically switches to standby after 20

minutes of inactivity.



Line Input

Connect the AV receiver's “Sub Out” to the subwoof-

er's “Line Input” using a mono RCA cable (optionally

with an additional Y adapter).



Line Output

Here, you can connect a second subwoofer for added

bass or to compensate for resonant frequencies in

the room.

 Low Pass – Full Range

With the switch on “LOW PASS”, the built-in con-

trols

for “Phase” and “Frequency” are

activated.

With the switch on “FULL RANGE” (recommended

setting), these parameters are controlled by the

AV receiver.



Level

Use the “LEVEL” control to adjust the subwoof-

er's volume. In the receiver's bass management

section, set the bass level to a high value, i.e.,

between 6 and 12 dB. Next, set the subwoofer's

What the icons mean

The lightning/arrow symbol

inside an equilateral triangle

informs the user about the

possibility of a dangerous, non-

isolated electrical current

inside the device housing,

indicating the risk of

electrical shock.

The exclamation mark within

the equilateral triangle, which

can be seen on the back of the

unit, indicates that there is

important operating and service

information for the user to read.

This product complies with the

following European Union

guidelines:

2004/108/EC and 2006/95/EC.

The “wastebin” symbol printed

on the type plates and amplier

labels of our products signies

that Lautsprecher Teufel ensures

the proper disposal of its sold

loudspeakers and subwoofers

according to Germany's

Electrical and Electronic

Equipment Act.

➒







➑

➓









{

This product complies with DIN

EN 61140 (VDE 0140-1) and IEC

60417 of protection class II. It

only requires a two-pin round

plug (included) and not an

earthed plug. The plug has a

reinforced or double-shielded

casing to prevent electrical

shock.

Attention:

The separating equipment of

this equipment is the mains

plug, this separating equipment

must be usable without

difculties.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Teufel System 4 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info