562454
6
Zoom out
Zoom in
Vorherige Seite
1/8
Nächste Seite
6
Adjusting and use
Adjusting amplifier/AV receiver and
Subwoofer
Most ampli ers/AV receivers feature a menu with speaker set-
tings (referred to as “Speaker Setup” or similar).
Ampli er/AV receiver setup
Subwoofer to “on”
Crossover frequency for subwoofer:
100 Hz, if satellites with 130 mm midrange speakers are
connected.
80 Hz, if satellites with 160 mm midrange speakers are
connected.
Volume of the subwoofer to more than 75 %
Subwoofer setup
• Switch 6 “Off • Auto • On“ to “Auto“.
• Switch 8 “Low Pass Full
Range“ to
Full Range“
(switch set-
ting: right)
.
• Control 3
“Volume“ to center position.
• Control 5 “Frequency“ to the right until it stops.
With these settings, the subwoofer will work optimally and
the automatic activation/deactivation is functioning properly.
You can make the nal ne tuning later on your ampli er/AV
receiver.
Subwoofer setup with non-adjustable ampli er/
AV receiver
If your ampli er/AV receiver does not provide the above op-
tions, you can make the most important settings directly on the
subwoofer. To do so, you will need a CD or DVD with adequate,
powerful sound.
• Set switch 8 “Low Pass • Full Range” to the left to “Low
Pass”. This activates the controlrs 5 “Frequency” and 7
“Phase”.
Set the crossover frequency with the controller 5 “Frequen-
cy” to about 100 Hz (fourth mark). This sets the subwoofer to
reproduce only frequencies up to 100 Hz.
Set the control 7 “Phase“ to “0°.
Set the control 3
“Volume“ to center position.
Now make an audition and then adjust the volume control
3 “Volume” until the subwoofer is clearly audible and adjust
the control 5 “Frequency” until the bass is strong but not
booming.
Once you have set the best sound, move the control 7
“Phase” several times until it stops in both directions. If you
notice a marked improvement in sound here, nd the optimal
setting. Otherwise, leave the knob to “0°
Optimise the settings with other CDs/DVDs and different
volumes.
Automatic activation/deactivation
With switch 6 “OffAutoOn” you can switch the operating
state:
Off Standby
Auto The subwoofer activates as soon as an audio signal is
present on the input jack 1 “Line In”. If there is no audio
signal for some period of time, the subwoofer switches
to standby.
On: The subwoofer is continually activated.
3
5
7
8
6
3
5
7
8
6
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Teufel T 2300 SW wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info