606888
1
Zoom out
Zoom in
Vorherige Seite
1/2
Nächste Seite
Meteodata 140 S 24V KNX 1409201
Meteodata 140 S 24V GPS KNX 1409204
Weather station
307032 02
1. Designated use
2. Safety instructions
The weather station measures temperature, brightness and wind
speed. A rain sensor is also installed on the top of the device. The
device is designed for use on buildings.
Time/date and position can be received via an integrated GPS
module (with Meteodata 140 S 24V GPS KNX – 1409204).
ETS (Engineering Tool Software) enables application programs
to be selected, specific parameters and addresses to be assigned
and transferred to the device.
Rain is only detected when the rain sensor is sufficiently wet.
There can be a delay between the first raindrops in a shower to
the point where rain is detected.
When the rain stops, and despite heating, it can take several
minutes before the sensor is dry again and the
device is able to detect that correctly.
Caution: When it is windy, awnings/blinds take time to retract.
Configure the wind thresholds below the value provided by the
awning/blinds manufacturer.
Rain sensor becomes hot during use
Do not touch the rain sensor.
3. Description
4. Installation
1 Rain sensor with heating
2 three light sensors (front, right and left)
3 Programming push button and LED for the physical
address
4 Rotor
5 Temperature sensor
6 Wall bracket with connection for supply 24 V and bus
connection (KNX)
Do not install the wind sensor in a sheltered position.
Avoid shadows (e.g. from masts etc.) and reflected
light.
Pay attention to mounting position
– Rain sensor pointing up
– Rotor pointing down
Wall-mounting
Secure the wall bracket to the wall etc. with the screws
and washers provided (see chap. 5).
The washers are important to achieve the IP 44 protection
rating.
Feed the cables through the rubber seals and insert in
the terminals.
Loosen the screws
.
Push down the weather station until it clicks into place.
Tighten screw .
Install the weather station horizontally and
tighten screws .
Rain sensor
Rotor
Screws:
Installation should only be carried out by a
professional electrician.
Please note the provisions of EN 50428 for switches or similar
installations for use in building system technology regarding
the correct installation of bus lines and setting up of devices.
Tampering with, or making modifications to, the device will
invalidate the guarantee.
Observe extra-low voltage.
1
2
3
4
6
5
1

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Theben Meteodata 140 S 24V KNX - 1409201 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Theben Meteodata 140 S 24V KNX - 1409201

Theben Meteodata 140 S 24V KNX - 1409201 Bedienungsanleitung - Deutsch - 97 seiten

Theben Meteodata 140 S 24V KNX - 1409201 Bedienungsanleitung - Deutsch - 2 seiten

Theben Meteodata 140 S 24V KNX - 1409201 Bedienungsanleitung - Englisch - 78 seiten

Theben Meteodata 140 S 24V KNX - 1409201 Bedienungsanleitung - Holländisch - 86 seiten

Theben Meteodata 140 S 24V KNX - 1409201 Bedienungsanleitung - Holländisch - 2 seiten

Theben Meteodata 140 S 24V KNX - 1409201 Bedienungsanleitung - Französisch - 2 seiten

Theben Meteodata 140 S 24V KNX - 1409201 Bedienungsanleitung - Französisch - 87 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info