Bedienungsanleitung Thetford Basic Line 340 (Seite 11 von 14) (Englisch)

576948

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

OPERATION

Burner Operation

The burners on the appliance have fixed aeration and no adjustment is required. The burners

should flame as follows:-

Propane - The flames should burn quietly with a blue/green colour with no sign of yellow tips.

Butane - Normally on initial lighting, a small amount of yellow tipping will occur and then

slightly increases as the burner heats up.

1. Ensure gas cylinder/supply is connected and turned on. In the event of a gas smell turn off at

gas cylinder/mains and contact supplier.

2. Flame supervision: Each burner is controlled individually and is monitored by a

thermocouple probe. In the event of the burner flames being accidentally extinguished, turn

off the burner control and do not attempt to re-ignite the burner for at least one minute.

3. To light: Push in the control knob and turn to full rate – see Fig.1. Hold a lighted match or

taper to the burner and push the control knob in and hold. It is necessary to hold the knob

depressed after the burner has ignited for approximately 10 - 15 seconds, to allow the

thermocouple probe to reach temperature, before releasing the knob. Should the flame go

out when the knob is released, the procedure should be repeated holding the knob

depressed for slightly longer.

4. For models fitted with optional Spark Ignition the procedure is similar:-

Models with Auto Spark Ignition – pushing the control knob automatically starts the

spark ignition circuit . To light the burner follow the procedure in (3) above except the

burner is automatically ignited.

Models with Manual Spark Ignition – follow the procedure in (3) above, except that the

burner can be ignited by depressing the ignition button located on the fascia.

If the burner has not lit within 15 seconds the control knob should be released and the

burner left for at least 1 minute before a further attempt to ignite the burner.

5. For simmering, turn the knob further anti-clockwise to the low rate position.

6. To turn off: Turn the control knob until the line on the control knob is aligned with the dot on

the control panel. Always make sure the control knob is in the off position when you have

finished using the hotplate burners.

WARNING

• When cooking, young children should be kept away.

• Glass lids may shatter when heated. Turn off all burners before shutting

the lid.

• Spillage on the lid surface should be removed before opening the lid

IMPORTANT

• Series 330 - will support 200mm Ø pans on the outer burners and

180mm Ø pan on the central burner – see Fig. 2

• Series 340 & 345 will support 3 x 200mm Ø pans – see Fig. 2

• Avoid old or misshapen pans as these may cause instability.

• The lid must be opened fully prior to using the hotplate burners.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Thetford Basic Line 340 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Thetford Basic Line 340

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info