Bedienungsanleitung Thetford S-OH70000 (Seite 11 von 15) (Englisch)

576908

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

Regulations And Standards

In your own interest of safety, it is law that all gas appliances are installed and serviced by

an approved competent person, in accordance with the local and National/European

standards in force. Failure to install the appliance correctly could invalidate any warranty or

liability claims and lead to prosecution. Particular attention shall be given to the

requirements regarding ventilation. Read the instructions before installing or using this

appliance.

Ventilation

This appliance is suitable for installation into Holiday Homes, Touring Caravans and Boats.

In all cases the national standards with regard to ventilation for the particular vehicle into

which the appliance is to be installed must be adhered to.

The European Standard EN1949 - "Specification for the installation of LPG systems in

leisure and other road vehicles", specifies appliances be installed in accordance with the

manufacturer’s instructions, including the adequate provision to avoid the accumulation of

un-burnt gases. We recommend a floor vent, venting to the outside, with minimum size

Ø12mm, maximum Ø50mm, which should be baffled to prevent direct draughts to the

appliance.

Location of Appliance

This appliance maybe installed in a kitchen/kitchen diner but NOT in a room containing a

bath or a shower. LP gas appliances must not be fitted below ground level. e.g. in a

basement.

Position

A cutout should be prepared as shown in the enclosed diagrams. The cutout MUST

comply with the dimensions shown and include the low ventilation indicated by in the

diagrams.

A horizontal distance of 200mm must exist between the edge of the burners and

combustible material unless protected by a layer of non-combustible material. Unless the

appliance is fitted with a glass lid a non-combustible heat shield (splash back) must be

fitted onto the rear wall directly behind the appliance.

The appliance should be fixed in place using the fixing screw positions located in the front

trim assembly. Depending on model these are located as follows:-

2 in each side trim of the Grill opening

2 in each side trim of the Oven opening

Make sure the appliance is fully home in the cabinet/aperture before fixing in place.

This appliance must be positioned free from draughts, which may affect the combustion,

and in a manner that will prevent the accumulation of unburnt gas. When in use ensure

that air vents are not inadvertently blocked or shut off. Ensure all combustible materials

such as curtains and shelves are well clear of the appliance.

On completion of the installation a warning notice complying to EN721 Annex A should be

affixed adjacent to the appliance.

INSTALLATION

•

After installation the appliance MUST be tested for soundness

• The gas supply pressure to which this appliance is connected MUST not

rise or fall by more than 2.5mbar from nominal, when all appliances

connected to the supply are operated simultaneously.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Thetford S-OH70000 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Thetford S-OH70000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info