576926
11
Zoom out
Zoom in
Vorherige Seite
1/13
Nächste Seite
11
1. Ensure gas supply is connected and turned on.
2. Push in the control knob and turn anticlockwise to full rate – large flame ( ) Fig. 1.
3. Continue holding the knob depressed whilst the automatic ignition lights the burner. For
manual models hold a lighted match or taper to the burner.
4. After the burner is lit continue depressing the knob for approximately 10 - 15 seconds.
5. Release knob and turn to required heat setting – see Fig. 1.
6. If burner has not lit within 15 seconds, release knob and wait at least 1 minute before
repeating operations (2) to (5).
7. To turn off, rotate the control knob until the line on the knob is aligned with dot on the
control panel.
Always make sure the control knob is in the off position when you have finished using the
hotplate burners.
DO'S AND DON'TS
DO Read the user instructions carefully before using the appliance for
the first time.
DO Allow the burners to heat before using for the first time, in order
to expel any smells before the introduction of food.
DO Clean the appliance regularly.
DO Remove spills as soon as they occur.
DO Check that controls are in the off position when finished.
DO NOT Allow children near the appliance when in use. Turn pan handles
away from the front so that they cannot be caught accidentally.
DO NOT Allow fats or oils to build up in the base of the hotplate.
DO NOT Use abrasive cleaners or powders that will scratch the surfaces of
the hotplate.
DO NOT Under any circumstances use the appliance as a space heater.
LEAKS
If a smell of gas apparent, the supply should be turned off at the cylinder IMMEDIATELY.
Extinguish naked lights including cigarettes and pipes. Do not operate electrical switches. Open
all doors and windows to disperse any gas escape. Butane/Propane gas is heavier than air;
any gas escaping will therefore collect at low level. The strong unpleasant smell of gas will
enable the general area of the leak to be detected. Check that the gas is not escaping from an
unlit appliance. Never check for leaks with a naked flame; leak investigation should be carried
out using a leak detector spray or soapy solution.
This appliance needs little maintenance other than cleaning. All parts should be cleaned using
warm soapy water. Do not use abrasive cleaners, steel wool or cleansing powders. When
cleaning the burner ring it is essential to ensure that the holes do not become blocked. The
control knobs are a push fit and can be removed for cleaning. They are interchangeable without
affecting the sense of operation.
ALL SERVICING MUST BE CARRIED OUT BY AN APPROVED COMPETENT PERSON.
AFTER EACH SERVICE THE APPLIANCE MUST BE CHECKED FOR GAS SOUNDNESS.
OPERATION
GB
MAINTENANCE & SERVICING
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Thetford SERIE 930 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Thetford SERIE 930

Thetford SERIE 930 Bedienungsanleitung - Deutsch - 17 seiten

Thetford SERIE 930 Bedienungsanleitung - Holländisch - 17 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info