Bedienungsanleitung Topcom twintalker 1400 micro sp (Seite 4 von 100) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

368335

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

4 TOPCOM TWINTALKER 1400

TOPCOM TWINTALKER 1400

• Replacing or modifying the antenna may affect the PMR radio speciﬁcations and violate the CE regulations.

Unauthorised antennas could also damage the radio.

3.6 NOTES

• Do not touch the antenna while transmitting, it could affect the range.

• Remove the battery if the device is not going to be used for a long period.

4 CLEANING AND MAINTENANCE

•To clean the unit, wipe with a soft cloth dampened with water. Don’t use a cleaner or solvents on the unit; they can

damage the case and leak inside, causing permanent damage.

• Battery contacts may be wiped with a dry lint-free cloth.

•If the unit gets wet, turn it off and remove the batteries immediately. Dry the battery compartment with a soft cloth

to minimize potential water damage. Leave the cover off the battery compartment overnight or until completely

dry. Do not use the unit until completely dry.

5 DISPOSAL OF THE DEVICE

Dispose of the unit and used batteries in an environment friendly manner.

Do not dispose of batteries in a normal household garbage.

6 USING A PMR DEVICE

To communicate between PMR devices they need to be set all on the same channel and within receiving range (up to

max. 3 km in open ﬁeld). Since these devices use free frequency bands (channels), all devices in operation share these

channels(total 8 channels). Therefore, privacy is not garanteed. Anybody with a PMR set to your channel can overhear

the conversation.

If you want to communicate (transmitting a voice signal) you need to press the - button (Push to talk). Once this

button pressed, the device will go into transmit mode and you can speak into the microphone. All other PMR devices

in range , on the same channel and in standby mode (not transmitting) will hear your message. You need to wait until

the other party stops transmitting before you can reply to the message. At the end of each transmission the unit will

send a beep. To reply, just press the - button and speak into the microphone.

7 GETTING STARTED

7.1 REMOVING/INSTALLING THE BELT CLIP

1. To remove the clip from the unit, push the belt clip (b) towards the antenna,

while pulling the clip tab (a).

2. When re-installing the belt clip, a click indicates the BeltClip is locked into

position.

7.2 BATTERY INSTALLATION

1. Remove the belt clip (§ 7.1).

2. Press the battery cover and slide it away from the antenna. (c)

3. Install three ‘AAA’ alkaline or rechargeable batteries following the polarity as

shown.

4. Re-install the Battery Cover (c) and Belt Clip (§ 7.1).

PTT

If 2 or more users press the - button at the same time the reciever will receive

only the stongest signal and the other signal (s) will be supressed. Therefore you

should only transmit a signal (press - button) when the channel is free .

PTT

1 x AAA

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Topcom twintalker 1400 micro sp Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info