Bedienungsanleitung Tristar AC-5560 (Seite 7 von 84) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch)

657372

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

• Twist both ends of the exhaust hose into the square xing clip and the

at xing clip.

• Insert the square xing clip into openings at back of the air conditioner.

• Put the other end of the exhaust hose to the near windowsill.

WINDOW SLIDER KIT INSTALLATION

The installation manner of window slider kit is mostly in “horizontal” and

“vertical”, No much dierence in actual process.

Internal Tank Water Full Alarm Function

The inner water tank in the air-conditioner has one water level safety

switches, it controls water level. When water level reaches an anticipated

height, the water full indicator lamp lights up. (If water pump is damaged,

when the water is full, please remove the rubber blockage at the bottom

of unit, and all water will drain outside.)

CLEANING MAINTENANCE

• Before cleaning, be sure to disconnect the unit from any electric supply

outlet.

• First clean the surface with a neutral detergent and wet cloth, and then

wipe it with a dry cloth.

• Do not use gasoline or other chemicals to clean the unit.

• Do not wash the unit directly.

• If the conditioner is damaged, please contact the dealer or repair shop.

Air Filter

• If the air lter becomes clogged with dust/dirt, the air lter should be

cleaned once every two weeks.

• Open the air inlet grille and take o air lter.

• Clean the air lter with neural detergent in lukewarm (40°C) and dry it

up in the shade.

• Putting the air lter into the inlet grille, replace the components as

they were.

TROUBLE SHOOTING

Troubles Possible Causes Suggested Remedies

The unit

does not

start when

pressing on/

o button

• Water full indicator lamp blinks, and

water tank is full.

• Room temperature is higher than

the setting temperature. (Electric

heating mode)

• Room temperature is lower than

the setting temperature. (Cooling

mode)

• Dump the water out

of the water tank.

• Reset the temperature

The unit

doesn’t cool

enough

• The doors or windows are not closed.

• There are heat sources inside the

room.

• Exhaust air hose is not connected

or blocked.

• Temperature setting is too high.

• Air inlet is blocked.

• Make sure all the

windows and doors

are closed.

• Remove the heat

sources if possible

• Connect or clean the

exhaust air hose.

• Reset the temperature

• Clean the air inlet.

Auto Power-

O in heat-

ing mode

Heating protection, when the temper-

ature at the air outlet exceeds 70

the unit will power o automatically.

Restart the unit at

enough lower room

temperature.

Noisy • The ground is not level or not at

enough

• The sound comes from the owing

of the refrigerant inside the air

conditioner

• Place the unit on a

at, level ground if

possible

• It is normal.

Air conditioner

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tristar AC-5560 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info