Bedienungsanleitung Tronic TLG1000C4-01 IAN 87964 (Seite 46 von 52) (Französisch, Italienisch)

737168

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

TLG 1000 C4

Operating status displays

The various displays have the following meanings:

■ The LED ﬂ ashes red and green once per second and the bars on the battery

symbol alternately move from the bottom to the top and vice versa: The bat-

teries are being alternately charged and discharged. (Refresh-Function: older

or long stored batteries are being refreshed.)

■ The LED ﬂ ashes green once per second and the bars in the battery symbol

are moving from the bottom to the top: A deeply discharged battery is being

gently recharged with a reduced current.

■ The LED glows constantly red and the bars in the battery symbol are moving

from the bottom to the top: The batteries are being charged with the maximum

charge current.

■ The LED glows constantly green and all bars in the battery symbol glow

continuously: The batteries are fully charged and the battery charger has

switched to trickle charge.

Calculating the average charging time

Depending on the type, age and remaining charge in the batteries, the charging

process can take various lengths of time. The average charge time can be cal-

culated using the following formula. Take note however that the times given are

only guiding values.

Charging Time (min) = Battery capacity (mAh) x 1.4 x 60

Charging current of the device (mA)

Automatic charging control / Retention charging

This battery charger controls the charging time for batteries of the types Ni-Cd

and Ni-MH separately. This control is based on the –Δ U ("minus Delta U")

calculation. In mathematics, with Delta Δ diﬀ erences are indicated. In this case,

"Minus Delta U" means a negative voltage diﬀ erence.

This charge identiﬁ cation makes itself useful in the following eﬀ ects: Should a

battery be charged with a constant current, its voltage rises continuously. When

a battery is full, its voltage reaches a maximum but falls again slightly with further

current ﬂ ow. This light fall in voltage is recognised by the charging electronics

and the charge process is terminated. The battery charger automatically switches

to "Retention charging". This means that the batteries are no longer being loaded

with constant current, instead, with short current pulses. This counteracts the self-

discharge and the batteries are kept in a state of full charge.

Timer control

In addition, this battery charger has a timer control which automatically switches

over to retention charging after 17 hours. This serves as an additional protection

against overcharging should the charge termination not respond due to a possibly

defective battery.

IB_87964_TLG1000C4_DE_CH.indb 43IB_87964_TLG1000C4_DE_CH.indb 43 27.02.13 10:5927.02.13 10:59

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tronic TLG1000C4-01 IAN 87964 Seite 46

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Tronic TLG1000C4-01 IAN 87964

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info